Ads
related to: do you need a subwoofer for turntable speakers to run a system video card
Search results
Results From The WOW.Com Content Network
Phono input is a set of input jacks, usually mini jacks or RCA connectors, located on the rear panel of a preamp, mixer or amplifier, especially on early radio sets, to which a phonograph or turntable is attached. [1] Modern phono cartridges give a very low level output signal of the order of a few millivolts which the circuitry amplifies and ...
So for a 16-bit digital system, the Dynamic Range is 20·log(2 16 − 1) ≈ 96 dB. Sample accuracy/synchronisation Not as much a specification as an ability. Since independent digital audio devices are each run by their own crystal oscillator, and no two crystals are exactly the same, sample rate will be slightly different. This will cause the ...
Turntablists typically manipulate records on a turntable by moving the record with their hand to cue the stylus to exact points on a record, and by touching or moving the platter or record to stop, slow down, speed up or, spin the record backwards, or moving the turntable platter back and forth (the popular rhythmic "scratching" effect which is ...
Acoustic Research was a Cambridge, Massachusetts-based company that manufactured high-end audio equipment. The brand is now owned by VOXX.Acoustic Research was known for the AR-3 series of speaker systems, which used the 12 in (300 mm) acoustic suspension woofer of the AR-1 with newly designed dome mid-range speaker and high-frequency drivers.
Before the bass management system, there is a LFE channel. After the bass management system, there is a subwoofer signal. A common misunderstanding is the belief that the LFE channel is the subwoofer channel. The bass management system may direct bass to one or more subwoofers (if present) from any channel, not just from the LFE channel. Also ...
Using a crossover to separate the sound into low, middle and high frequencies can lead to a "cleaner", clearer sound (see bi-amplification) than routing all of the frequencies through a single full-range speaker system. Nevertheless, many small venues still use a single full-range speaker system, as it is easier to set up and less expensive.
The output from a DJ mixer is typically plugged into a sound reinforcement system or a PA system at a dance, rave, nightclub or similar venue or event. The sound reinforcement system consists of power amplifiers which amplify the signal to the level that can drive speaker enclosures, which since the 1980s typically include both full-range speakers and subwoofers for the deep bass sounds.
An active full-range loudspeaker. Powered speakers, also known as self-powered speakers and active speakers, are loudspeakers that have built-in amplifiers.Powered speakers are used in a range of settings, including in sound reinforcement systems (used at live music concerts), both for the main speakers facing the audience and the monitor speakers facing the performers; by DJs performing at ...