Ad
related to: multilink suspension vs double wishbone replacement pads
Search results
Results From The WOW.Com Content Network
A multi-link suspension is a type of independent vehicle suspension having three or more control links per wheel. [1] These arms do not have to be of equal length, and may be angled away from their "obvious" direction. It was first introduced in the late 1960s on the Mercedes-Benz C111 [2] and later on their W201 and W124 series. [3] [4]
A short long arms suspension (SLA) is also known as an unequal-length double wishbone suspension. The upper arm is typically an A-arm and is shorter than the lower link, which is an A-arm or an L-arm, or sometimes a pair of tension/compression arms. In the latter case, the suspension can be called a multi-link, or dual-ball joint suspension.
Double wishbone suspension; arms and knuckle painted yellow. In automobiles, a double wishbone suspension is an independent suspension design using two (occasionally parallel) wishbone-shaped arms to locate the wheel. Each wishbone or arm has two mounting points to the chassis and one joint at the knuckle.
For premium support please call: 800-290-4726 more ways to reach us
The twist-beam provided a cost saving of €100 per car compared to multi-link rear suspension, [4] although the version used in the 2009–2018 Opel Astra also employed a Watts linkage at a cost of €20 to address the drawbacks and provide a competitive and cost-effective rear suspension. [4]
For premium support please call: 800-290-4726 more ways to reach us
In either case, the difference is that the single bottom wishbone is replaced by a pair of suspension links forming a trapezoidal four-bar linkage. This allows the kingpin to pivot about a pivot point nearer the center of the wheel's contact patch instead of the traditional pivot point at the ball joint of the bottom wishbone. [2]
The double-wishbone suspension can also be referred to as ‘double A-arm,’ though the arms themselves can be A-shaped, L-shaped, or even a single bar linkage. The complete TAK-4 independent suspension system set-up also includes a subframe which contains the axle differential, half shafts, and wheel ends with steering attachments and brakes.