Ads
related to: high pressure diaphragm valve definition
Search results
Results From The WOW.Com Content Network
Diaphragm valves can be controlled by various types of actuators e.g. manual, pneumatic, hydraulic, electric etc. The most common diaphragm valves use pneumatic actuators; in this type of valve, air pressure is applied through a pilot valve into the actuator which in turn raises the diaphragm and opens the valve. This type of valve is one of ...
The basic working principle of an air-operated double diaphragm pump. Cross-section sketch of diaphragm fuel pump Air-operated double diaphragm pump. A diaphragm pump (also known as a Membrane pump) is a positive displacement pump that uses a combination of the reciprocating action of a rubber, thermoplastic or teflon diaphragm and suitable valves on either side of the diaphragm (check valve ...
Used in oil and gas wellheads, where the pressure drop is high. (Not to be confused with engine choke valve, below.) Diaphragm valve or membrane valve, controls flow by movement of a diaphragm. Used in pharmaceutical applications; Gate valve, mainly for on–off control, with low pressure drop; Globe valve, good for regulating flow. Uses a ...
A diaphragm pressure tank is a tank which has pressurant sealed inside on one side of the diaphragm. It is favored in certain applications due to its high durability and reliability. This comes with a downside, as the vessel needs to be replaced in the case of a rupture of the diaphragm. [2]
An air-operated valve, also known as a pneumatic valve, is a type of power-operated pipe valve that uses air pressure to perform a function similar to a solenoid. As air pressure is increased, the compressed air starts to push against the piston or diaphragm walls which causes the valve to actuate. Whether the valve opens or closes depends on ...
The inlet pressure gauge will indicate this pressure. The gas then passes through the normally open pressure control valve orifice and the downstream pressure rises until the valve actuating diaphragm is deflected sufficiently to close the valve, preventing any more gas from entering the low pressure side until the pressure drops again.
A rod is connected to the center of the diaphragm so that it moves as the pressure is applied. The rod is then connected to a valve stem which allows the valve to experience the linear motion thereby opening or closing. A diaphragm actuator is useful if the supply pressure is moderate and the valve travel and thrust required are low.
Pneumatically-actuated globe valves and diaphragm valves are widely used for control purposes in many industries, although quarter-turn types such as (modified) ball and butterfly valves are also used. Control valves can also work with hydraulic actuators (also known as hydraulic pilots). These types of valves are also known as automatic ...