Search results
Results From The WOW.Com Content Network
In the oil industry, mud weight is the density of the drilling fluid and is normally measured in pounds per gallon (lb/gal) (ppg) or pound cubic feet (pcf) . [1] In the field it is measured using a mud scale or mud balance. Mud can weigh up to 22 or 23 ppg. A gallon of water typically weighs 8.33 pounds (or 7.48 ppg).
P = 0.052 * mud weight * true vertical depth. taught in almost all petroleum engineering courses worldwide, the mud weight (MW) is expressed in pounds per U.S. gallon, and the true vertical depth (TVD) is expressed in feet, and 0.052 is a commonly used conversion constant that can be derived by dimensional analysis:
In the oil industry, estimated pore pressure is measured in pounds per square inch (psi), but is converted to equivalent mud weight and measured in pounds per gallon (lb/gal) to more easily determine the amount of mud weight required to prevent the fluid or gas from escaping and causing a blowout or wellbore failure.
Drilling fluids also support portion of drill-string or casing through buoyancy. Suspend in drilling fluid, buoyed by force equal to weight (or density) of mud, so reducing hook load at derrick. Weight that derrick can support limited by mechanical capacity, increase depth so weight of drill-string and casing increase.
See mud log for an example of the corrected d-exponent plotted on a mud log. The parameter is an extension ("correction", hence the "c" notation) to the d-exponent method previously used for estimating formation pore pressures. The extension consists of a correction for the mud weight in use, compared to "standard" mud for the region.
HSP = 0.052 × MW × TVD', where MW (Mud Weight or density) is the drilling-fluid density in pounds per gallon (ppg), TVD is the true vertical depth in feet and HSP is the hydrostatic pressure in psi. The 0.052 is needed as the conversion factor to psi unit of HSP. [10] [11] To convert these units to SI units, one can use: 1 ppg ≈ 119.826 ...
ppg – pounds per gallon; PPI – post production inspection/intervention; PPI – post pipelay installation; PPL – pre-perforated liner; pptf – pounds (per square inch) per thousand feet (of depth) – a unit of fluid density/pressure [citation needed] PPS – production packer setting; PPU – pipeline process and umbilical
The cup is used to hold a fixed amount of fluid so it can be weighed. A slider-weight can be moved along the beam, and a bubble indicates when the beam is level. Density is read at the point where the slider-weight sits on the beam at level. Calibration is done using a liquid of known density (often fresh water) by adjusting the counter weight.