Ads
related to: 2 inch ground auger bit for concrete
Search results
Results From The WOW.Com Content Network
A post-hole auger. An earth auger, earth drill, or post-hole auger is a drilling tool used for making holes in the ground. [1] It typically consists of a rotating vertical metal rod or pipe with one or more blades attached at the lower end, that cut or scrape the soil.
These 3/16-inch Bosch bits are the perfect size for drilling pilot holes for ¼-inch Tapcon concrete screws, and more than provide the minimum 1-inch depth required.
The bit shown in the picture is a modern design for use in portable power tools, made in the UK in about 1995. It has a single spur, a single radial cutting edge and a single flute. Similar auger bits are made with diameters from 6 mm (3/16 in) to 30 mm (1 3/16 in).
[2] Boring machines use twist auger bits usually ranging in size from 7 ⁄ 8 inch to 2 inches. The machines hold the bit perpendicular (square) to the face of the timber and are operated with both hands while the operator sits on the base to keep the machine from moving. Some machines can be set at an angle.
A continuous flight auger drill is used to excavate a hole and concrete is injected through a hollow shaft under pressure as the auger is extracted. Reinforcement is then inserted after the auger is removed. [1] This creates a continuous pile without ever leaving an open hole.
Drill bit sizes are written as irreducible fractions. So, instead of 78/64 inch, or 1 14/64 inch, the size is noted as 1 7/32 inch. Below is a chart providing the decimal-fraction equivalents that are most relevant to fractional-inch drill bit sizes (that is, 0 to 1 by 64ths).