Search results
Results From The WOW.Com Content Network
The direct-coupled amplifier was influential in the development of Fairchild's uA709 operational amplifier by Bob Widlar, which Noyce knew about as he was one of the founders of Fairchild Semiconductors. The direct-coupled amplifier is also the basis for Philco's Mark I hearing aid, which used the circuit built with silicon alloy transistors.
Schematic of an inverter using a vibrator as a chopper. In electronics, a chopper circuit is any of numerous types of electronic switching devices and circuits used in power control and signal applications. A chopper is a device that converts fixed DC input to a variable DC output voltage directly.
Charge amplifier for piezoelectric sensors. Practical charge amplifiers usually include additional stages like voltage amplifiers, transducer sensitivity adjustment, high and low pass filters, integrators and level monitoring circuits. The charge signals at the input of a charge amplifier can be as low as some fC (FemtoCoulomb = 10 −15 C). A ...
An amplifier, electronic amplifier or (informally) amp is an electronic device that can increase the magnitude of a signal (a time-varying voltage or current). It is a two-port electronic circuit that uses electric power from a power supply to increase the amplitude (magnitude of the voltage or current) of a signal applied to its input ...
In electronics, a common-gate amplifier is one of three basic single-stage field-effect transistor (FET) amplifier topologies, typically used as a current buffer or voltage amplifier. In this circuit, the source terminal of the transistor serves as the input, the drain is the output, and the gate is connected to some DC biasing voltage (i.e. an ...
Figure 2: A negative-feedback amplifier. The circuit can be explained by viewing the transistor as being under the control of negative feedback.From this viewpoint, a common-collector stage (Fig. 1) is an amplifier with full series negative feedback.
This circuit operates by passing a current that charges or discharges the capacitor during the time under consideration, which strives to retain the virtual ground condition at the input by off-setting the effect of the input current: Referring to the above diagram, if the op-amp is assumed to be ideal, then the voltage at the inverting ...
DC current is cancelled in the output, allowing a smaller output transformer to be used than in a single-ended amplifier. However, the push–pull amplifier requires a phase-splitting component that adds complexity and cost to the system; use of center-tapped transformers for input and output is a common technique but adds weight and restricts ...