Search results
Results From The WOW.Com Content Network
Mercury rectifier on display in the Beromünster AM transmitter in Switzerland, before being decommissioned.Three-phase full-wave rectifier with six anodes. A mercury-arc valve or mercury-vapor rectifier or (UK) mercury-arc rectifier [1] [2] is a type of electrical rectifier used for converting high-voltage or high-current alternating current (AC) into direct current (DC).
Between the circuit's input and output is a diode that performs half-wave rectification, allowing substantial current flow only when the input voltage is around a diode drop higher than the output terminal. The output is connected to a capacitor of value and resistor of value in parallel to ground. The capacitor is charged as the input voltage ...
English: A diagram showing types of direct current (battery, half-wave and full wave rectification). Date: 19 September 2009: ... Current rectification diagram.png, ...
a full-wave precision rectifier circuit to create the absolute value of the input signal, which is fed into a log amplifier, doubled and fed into an exponential amplifier as a means of deriving the square-law transfer function = | |, and then the time-average and square root are performed, similarly to above,
Typical HT supply circuit schematic. The HT supply was usually obtained from a full wave rectifier circuit similar to the one shown. In those sets that had no mains transformer (the so-called AC/DC design), the HT was obtained directly from the mains supply, either with a simple half wave rectifier or with a voltage doubler circuit.
The top plot shows the individual three phase signals, the middle plot shows the half-wave rectifier output in solid curve and the bottom plot shows the full-wave rectifier output in solid curve. The 'T' in time is the time period of individual signals and V p e a k {\displaystyle \scriptstyle V_{\mathrm {peak} }} is the amplitude of each of ...
The characteristics and components of ripple depend on its source: there is single-phase half- and full-wave rectification, and three-phase half- and full-wave rectification. Rectification can be controlled (uses Silicon Controlled Rectifiers (SCRs)) or uncontrolled (uses diodes). There is in addition, active rectification which uses transistors.
A valley-fill circuit is a type of passive power-factor correction (PFC) circuit. For purposes of illustration, a basic full-wave diode-bridge rectifier is shown in the first stage, which converts the AC input voltage to a DC voltage.