Search results
Results From The WOW.Com Content Network
When steam has reached this equilibrium point, it is referred to as saturated steam. Superheated steam or live steam is steam at a temperature higher than its boiling point for the pressure, which only occurs when all liquid water has evaporated or has been removed from the system.
[52] [53] The cut-up prescribed by whistle-maker Robert Swanson for 150 psig steam pressure was 0.35 x bell diameter for a plain whistle, which is about 1.45 x net bell cross-sectional area (subtracting stud area). [54] The Nathan Manufacturing Company used a cut-up of 1.56 x chamber cross-sectional area for their 6-note railway chime whistle. [55]
Superheated steam was widely used in main line steam locomotives. Saturated steam has three main disadvantages in a steam engine: it contains small droplets of water which have to be periodically drained from the cylinders; being precisely at the boiling point of water for the boiler pressure in use, it inevitably condenses to some extent in the steam pipes and cylinders outside the boiler ...
The saturated vapor pressure over water in the temperature range of −100 °C to −50 °C is only extrapolated [Translator's note: Supercooled liquid water is not known to exist below −42 °C]. The values have various units (Pa, hPa or bar), which must be considered when reading them.
The heated water/steam mixture then rises into the steam drum. Here, saturated steam is drawn off the top of the drum. In some [which?] services, the steam passes through tubes in the hot gas path, (a superheater) to become superheated. Superheated steam is a dry gas and therefore is typically used to drive turbines, since water droplets can ...
Steam in this state (in equilibrium with the liquid water which is being evaporated within the boiler) is named "saturated steam". For example, saturated steam at atmospheric pressure boils at 100 °C (212 °F). Saturated steam taken from the boiler may contain entrained water droplets, however a well designed boiler will supply virtually "dry ...
The vapor pressure of water is the pressure exerted by molecules of water vapor in gaseous form (whether pure or in a mixture with other gases such as air). The saturation vapor pressure is the pressure at which water vapor is in thermodynamic equilibrium with its condensed state.
Thermocompression evaporators may reach higher compression ratios - at a cost. A compression ratio of 2 is possible (and sometimes more) but unless the motive steam is at a reasonably high pressure (say, 16 bar g - 250 psig - or more), the motive steam consumption will be in the range of 2 kg per kg of suction vapors. A higher compression ratio ...