Search results
Results From The WOW.Com Content Network
Many circuits can be analyzed as a combination of series and parallel circuits, along with other configurations. In a series circuit, the current that flows through each of the components is the same, and the voltage across the circuit is the sum of the individual voltage drops across each component. [ 1 ]
See also: Diode logic § Active-high AND logic gate Open-collector buffers connected as wired AND.. The wired AND connection is a form of AND gate.When using open collector or similar outputs (which can be identified by the ⎐ symbol in schematics), wired AND only requires a pull up resistor on the shared output wire.
Series and parallel composition operations for series–parallel graphs. In graph theory, series–parallel graphs are graphs with two distinguished vertices called terminals, formed recursively by two simple composition operations. They can be used to model series and parallel electric circuits.
Norton's theorem and its dual, Thévenin's theorem, are widely used for circuit analysis simplification and to study circuit's initial-condition and steady-state response. Norton's theorem was independently derived in 1926 by Siemens & Halske researcher Hans Ferdinand Mayer (1895–1980) and Bell Labs engineer Edward Lawry Norton (1898–1983).
A simple electrical impedance-matching network requires one capacitor and one inductor. In the figure to the right, R 1 > R 2, however, either R 1 or R 2 may be the source and the other the load. One of X 1 or X 2 must be an inductor and the other must be a capacitor. One reactance is in parallel with the source (or load), and the other is in ...
On-die termination is implemented with several combinations of resistors on the DRAM silicon along with other circuit trees. DRAM circuit designers can use a combination of transistors that have different values of turn-on resistance. In the case of DDR2, there are three kinds of internal resistors 150ohm, 75ohm, and 50ohm.
The best-known bridge circuit, the Wheatstone bridge, was invented by Samuel Hunter Christie and popularized by Charles Wheatstone, and is used for measuring resistance. It is constructed from four resistors, two of known values R 1 and R 3 (see diagram), one whose resistance is to be determined R x , and one which is variable and calibrated R 2 .
A zero-ohm link or zero-ohm resistor is a wire link packaged in the same physical package format as a resistor. It is used to connect traces on a printed circuit board (PCB). This format allows it to be placed on the circuit board using the same automated equipment used to place other resistors, instead of requiring a separate machine to ...