Ads
related to: front wheel assembly
Search results
Results From The WOW.Com Content Network
The hub assembly is located between the brake drums or discs and the drive axle. A wheel is bolted on it. Depending on the construction, the end of the hub comes equipped with the splined teeth. They mate the teeth on the axle shaft. The axle hub spins along with the wheels bolted to it and provide power to the wheels in order to rotate.
Fork: a mechanical assembly that integrates a bicycle's frame to its front wheel and handlebars, allowing steering by virtue of its steerer tube; Fork crown: the point at which the two blades of the fork meet below the steerer tube. Fork end: paired slots on a fork or frame at
The wheel and tire assembly attach to the hub or spindle of the knuckle where the tire/wheel rotates while being held in a stable plane of motion by the knuckle/suspension assembly. In the attached photograph of a double-wishbone suspension, the knuckle is shown attached to the upper control arm at the top and the lower control arm at the bottom.
Spindles or uprights - Jaguar left and Holden Gemini right The wheel spindle in the illustration is colored red. In an automobile, the wheel spindle, sometimes called simply the spindle, is the part of the suspension system that carries the hub for the wheel and attaches to the upper and lower control arms.
The front-wheel-drive Renault 16 had a longitudinal engine and transaxle, with the engine behind the transaxle. The transaxle case was designed to allow the final-drive ring gear to be on either side of the pinion; this allowed the engine-transaxle assembly to be used in the rear-wheel-drive Lotus Europa , which had the engine in front of the ...
Hub-center steering (HCS) is one of several different types of front-end suspension/steering mechanisms used in motorcycles and cargo bicycles. Hub-center steering is characterized by the steering pivot points being inside the hub of the wheel, rather than above the wheel in the headstock as in the traditional layout.