Search results
Results From The WOW.Com Content Network
Frequent use of a serial port is for a direct computer-to-computer connection. This requires an adapter called a null modem, which isn't actually a modem in the traditional sense, but rather a connector plug that simply crosses the complementary pins on two serial ports so the two sides can communicate. A null modem typically connects the DTR ...
When the modem wants the computer to temporarily pause so the playback can catch up, it temporarily lowers the CTS (Clear to Send) signal on the RS-232 serial port. The modem re-raises the signal in time for the computer to resume sending audio data before the playback buffer becomes completely empty.
The current version of the standard is TIA-232-F Interface Between Data Terminal Equipment and Data Circuit-Terminating Equipment Employing Serial Binary Data Interchange, issued in 1997. The RS-232 standard had been commonly used with serial ports and serial cables. It is still widely used in industrial communication devices.
Reboot your modem/router - Sometimes the old "turn it off and on again" approach actually does work! Just wait about five minutes before turning it back on to make sure everything was reset. 4. Contact your Internet Service Provider (ISP) - If you're still not able to get
Dial-up doesn't work with phone services offered by cable companies. Check your physical phone connection - A loose cable or cord can often be the cause of a connection problem. Unplug all phone devices in your home - Unplug all phone devices in your home, then reconnect just the modem. Try to connect online, and if it works, plug in each ...
Data Terminal Ready (DTR) is a control signal in RS-232 serial communications, transmitted from data terminal equipment (DTE), such as a computer, to data communications equipment (DCE), for example a modem, to indicate that the terminal is ready for communications and the modem may initiate a communications channel.
Also, at this time, both modems will raise the DCD, or Data Carrier Detect signal, on the serial port. abcdef: abcdef: When the modems are connected, any characters typed at either side will appear on the other side. The person at computer A starts typing. The characters pass through the modem and appear on computer B's screen.
Since the control signals for a serial port can be driven by any digital signal, some applications used the control lines of a serial port to monitor external devices, without exchanging serial data. A common commercial application of this principle was for some models of uninterruptible power supply which used the control lines to signal loss ...