Search results
Results From The WOW.Com Content Network
A fixed-point representation of a fractional number is essentially an integer that is to be implicitly multiplied by a fixed scaling factor. For example, the value 1.23 can be stored in a variable as the integer value 1230 with implicit scaling factor of 1/1000 (meaning that the last 3 decimal digits are implicitly assumed to be a decimal fraction), and the value 1 230 000 can be represented ...
A scale factor of 1 ⁄ 10 cannot be used here, because scaling 160 by 1 ⁄ 10 gives 16, which is greater than the greatest value that can be stored in this fixed-point format. However, 1 ⁄ 11 will work as a scale factor, because the maximum scaled value, 160 ⁄ 11 = 14. 54, fits within this range. Given this set:
In logic simulation, a common mistake in evaluation of accurate models is to compare a logic simulation model to a transistor circuit simulation model. This is a comparison of differences in precision, not accuracy. Precision is measured with respect to detail and accuracy is measured with respect to reality. [16] [17]
4 bits – (a.k.a. tetrad(e), nibble, quadbit, semioctet, or halfbyte) the size of a hexadecimal digit; decimal digits in binary-coded decimal form 5 bits – the size of code points in the Baudot code, used in telex communication (a.k.a. pentad) 6 bits – the size of code points in Univac Fieldata, in IBM "BCD" format, and in Braille. Enough ...
Order of magnitude is a concept used to discuss the scale of numbers in relation to one another. Two numbers are "within an order of magnitude" of each other if their ratio is between 1/10 and 10. In other words, the two numbers are within about a factor of 10 of each other. [1] For example, 1 and 1.02 are within an order of magnitude.
E.g. binary128 has approximately the same precision as a 34 digit decimal number. log 10 MAXVAL is a measure of the range of the encoding. Its integer part is the largest exponent shown on the output of a value in scientific notation with one leading digit in the significand before the decimal point (e.g. 1.698·10 38 is near the largest value ...
This is usually measured in bits, but sometimes in decimal digits. It is related to precision in mathematics, which describes the number of digits that are used to express a value. Some of the standardized precision formats are: Half-precision floating-point format; Single-precision floating-point format; Double-precision floating-point format
Here the 'IEEE 754 double value' resulting of the 15 bit figure is 3.330560653658221E-15, which is rounded by Excel for the 'user interface' to 15 digits 3.33056065365822E-15, and then displayed with 30 decimals digits gets one 'fake zero' added, thus the 'binary' and 'decimal' values in the sample are identical only in display, the values ...