Search results
Results From The WOW.Com Content Network
In 1884, the US Ordnance Department increased the bullet weight of the 45–70 to 45–70–500, or a 45 caliber bullet, 70 grains of black powder, and a 500 grain bullet. [3] The new 45-70-500 loading was recorded with a muzzle velocity of 1315.7 feet, and generated 1525 ft lbs of energy at 100 yds, and 562.3 ft lbs of energy at 1,000 yards ...
These factors, along with Taylor’s dismissal of muzzle energy, allow many obsolete low powered large bore cartridges such as the .577/450 Martini-Henry and the .45-70 Government to have as much as twice the TKOF than the smaller bore general purpose hunting cartridges such as the .303 British and the .30-06 Springfield. For these reasons the ...
According to the US Army Ordnance Department tests, the 45-70-405 was loaded to 19,000 psi, [4] while the 45-70-500 was loaded to 25,000 psi [2] The average accuracy of the Springfield Model 1873 was a circle with an average radius of 1.7 inches at 100 yards, corresponding to an ~3.4 MOA.
The .460 S&W, which is a .45 caliber case slight longer than the .500 S&W, takes nearly the same bullets as the .45-70 (.452 vs. .458), and is a virtual twin to the .45-70 performance-wise. Even the guy at S&W who developed the .500 and .460 thinks the .460 is a better hunting cartridge (see here ).
Derived from the .50-60-400 Joslyn, the cartridge was developed after the unsatisfactory results of the .58 rimfire cartridge for the Springfield Model 1865 rifle. The .50-70 Government cartridge used the Benét internal center-fire primer design and became the official cartridge of the U.S. military in 1866 until being replaced by the .45-70 Government in 1873.
These rifles were made in a variety of calibers, both rimfire and centerfire, including the 12.17x42 mm rimfire, 12.17x44 mm rimfire and 12.17x44 mm rimmed centerfire Swedish and Norwegian cartridges, .43 Spanish (11.15x58mmR), .50-70, .40-70, .45-70 and later in .22 caliber.
Discover the latest breaking news in the U.S. and around the world — politics, weather, entertainment, lifestyle, finance, sports and much more.
Cutting speed may be defined as the rate at the workpiece surface, irrespective of the machining operation used. A cutting speed for mild steel of 100 ft/min is the same whether it is the speed of the cutter passing over the workpiece, such as in a turning operation, or the speed of the cutter moving past a workpiece, such as in a milling operation.