Search results
Results From The WOW.Com Content Network
A computer monitor is an output device that displays ... Most modern monitors have two different indicator light colors wherein if video-input signal was detected ...
The signal standard and pinout are backward-compatible with CGA, allowing EGA monitors to be used on CGA cards and vice versa. Early VGA cards also used this connector. VGA connector (DE-15) Became a nearly ubiquitous analog computer display connector after first being introduced with IBM x86 machines. Older VGA connectors were DE-9 (9-pin).
A composite monitor must have a two-dimensional approximately flat display device with circuitry to accept a composite signal with picture and synchronisation information, process it into monochrome chrominance and luminance, or the red, green, and blue of RGB, plus synchronisation pulses, and display it on a screen, which was predominantly a ...
Data Carrier Detect (DCD) or Carrier Detect (CD) is a control signal present inside an RS-232 serial communications cable that goes between a computer and another device, such as a modem. This signal is a simple "high/low" status bit that is sent from a data communications equipment (DCE) to a data terminal equipment (DTE), i.e., from the modem ...
No signal conversion is necessary, nor is there a loss of video quality when a DVI-to-HDMI adapter is used. [ 5 ] : §C The Consumer Electronics Control (CEC) capability allows HDMI devices to control each other when necessary and allows the user to operate multiple devices with one handheld remote control device.
In addition to digital, some DVI connectors also have pins that pass an analog signal, which can be used to connect an analog monitor. The analog pins are the four that surround the flat blade on a DVI-I or DVI-A connector. A VGA monitor, for example, can be connected to a video source with DVI-I through the use of a passive adapter. Since the ...
A bright dot defect or hot pixel is a group of three sub-pixels (one pixel) all of whose transistors are "off" for TN panels or stuck "on" for MVA and PVA panels. [2] This allows all light to pass through to the RGB layer, creating a bright pixel that is always on.
There is no switching signal to indicate S-Video. Some TVs can auto-detect the presence of the S-Video signal but more commonly the S-Video input needs to be manually selected. The same for the rare component YPbPr, which is in many cases implemented over a composite or RGB SCART.