Search results
Results From The WOW.Com Content Network
Electrical conduction of metals is a well-known phenomenon and is attributed to the free conduction electrons, which can be measured as sketched in the figure. The current density j is observed to be proportional to the applied electric field and follows Ohm's law where the prefactor is the specific electrical conductivity.
The Drude model of electrical conduction was proposed in 1900 [1] [2] by Paul Drude to explain the transport properties of electrons in materials (especially metals). Basically, Ohm's law was well established and stated that the current J and voltage V driving the current are related to the resistance R of the material.
Electrical conductivity of water samples is used as an indicator of how salt-free, ion-free, or impurity-free the sample is; the purer the water, the lower the conductivity (the higher the resistivity). Conductivity measurements in water are often reported as specific conductance, relative to the conductivity of pure water at 25 °C.
In solid-state physics, the valence band and conduction band are the bands closest to the Fermi level, and thus determine the electrical conductivity of the solid. In nonmetals, the valence band is the highest range of electron energies in which electrons are normally present at absolute zero temperature, while the conduction band is the lowest range of vacant electronic states.
The mass action law defines a quantity called the intrinsic carrier concentration, which for undoped materials: n i = n 0 = p 0 {\displaystyle n_{i}=n_{0}=p_{0}} The following table lists a few values of the intrinsic carrier concentration for intrinsic semiconductors , in order of increasing band gap.
Electrical conductivity is a measure of how well a material transports an electric charge.This is an essential property in electrical wiring systems. Copper has the highest electrical conductivity rating of all non-precious metals: the electrical resistivity of copper = 16.78 nΩ•m at 20 °C.
Similar to electron conduction, the electrical resistance of thin-film electrolytes depends on the applied electric field, such that when the thickness of the sample is reduced, the conductivity improves due to both the reduced thickness and the field-induced conductivity enhancement.
The conductivity of some metals can depend of the orientation of the sample with respect to the electric field. Sometimes even the electrical current is not parallel to the field. This possibility is not described because the model does not integrate the crystallinity of metals, i.e. the existence of a periodic lattice of ions.