Search results
Results From The WOW.Com Content Network
This could be a problem if the necessary precautions are not taken into account in the design of the board; the device can suffer the damage of the I/O components during the programming. Moreover, it’s important to connect the ISP lines to high impedance circuitry both to avoid a damage of the components by the programmer and because the ...
Check if you can visit other sites with a different browser - If you can go to another site, the problem may be associated the browser you're using. If you don't have another browser, download a supported one for free. 2. Check the physical connection - A loose cable or cord can often be the cause of a connection problem. Make sure everything ...
Perhaps the most comprehensive known and most discussed feature of ANSI/TIA-568 is the definition of the pin-to-pair assignments, or pinout, between the pins in a connector (a plug or a socket) and the wires in a cable. Pinouts are critical because cables do not function if the pinouts at their two ends aren't correctly matched.
Examples of CPE types include modems, routers, gateways, set-top boxes, and VoIP-phones. TR-069 was first published in May 2004, with amendments in 2006, 2007, 2010, July 2011 (version 1.3), [ 1 ] and November 2013 (version 1.4 am5) [ 2 ] The Home Gateway Initiative (HGI), Digital Video Broadcasting Project (DVB) and WiMAX Forum have endorsed CWMP.
Check your physical phone connection - A loose cable or cord can often be the cause of a connection problem. Unplug all phone devices in your home - Unplug all phone devices in your home, then reconnect just the modem. Try to connect online, and if it works, plug in each device one at a time until you find the one causing the problem.
Configuration design is a kind of design where a fixed set of predefined components that can be interfaced (connected) in predefined ways is given, and an assembly (i.e. designed artifact) of components selected from this fixed set is sought that satisfies a set of requirements and obeys a set of constraints.
Downstream traffic in active (top) vs. passive optical network. A passive optical network consists of an optical line terminal (OLT) at the service provider's central office (hub), passive (non-power-consuming) optical splitters, and a number of optical network units (ONUs) or optical network terminals (ONTs), which are near end users.
The connector on the Amiga 1000 uses crossover wiring, similar to a telephone handset. The connector wiring on the Apple computers, however, requires a polarized straight-through pinout. Using a telephone handset cable instead of the supplied cable could short out the +5 volt DC supply and damage the Apple computer or the keyboard. [12]