Ads
related to: matx case with good airflow pressure tank protector reviews
Search results
Results From The WOW.Com Content Network
Inside a gaming case during gameplay. 360° photograph. A full tower case. Accessories shown include: a fan controller, a DVD burner, and a USB memory card reader.. Cases can come in many different sizes and shapes, which are usually determined by the form factor of the motherboard since it is physically the largest hardware component in most computers. Consequently, personal computer form ...
In addition, some microATX cases require the use of low-profile PCI cards [7] and use power supplies with non-standard dimensions. [ 8 ] Compared to Mini-ITX , microATX motherboards have a maximum of four expansion slots and four DIMM slots, as opposed to the single expansion slot and two DIMM (or SO-DIMM [ 9 ] ) slots on Mini-ITX motherboards.
They are good for a limited amount of time from around 6–8 hours of cooling. Other designs are simply a pad that elevates the laptop so that the fans in the laptop are allowed greater airflow. Conductive cooling pads are not advisable for laptops that have fan vents built into the underside; the cooling pad blocks the vents, leading to ...
Poor airflow including turbulence due to friction against impeding components such as ribbon cables, or incorrect orientation of fans, can reduce the amount of air flowing through a case and even create localized whirlpools of hot air in the case. In some cases of equipment with bad thermal design, cooling air can easily flow out through ...
Mini-ITX boards can therefore often be used in cases designed for ATX, micro-ATX and other ATX variants if desired. Mini-ITX motherboards have only one expansion slot. Earlier Mini-ITX motherboards had a standard 33 MHz 5V 32-bit PCI slot, whereas newer motherboards use a PCI Express slot.
Comparison of the form factors for motherboards ATX, μATX (micro-ATX), DTX, mini-ITX and mini-DTX The DTX form factor is a variation of ATX specification [1] designed especially for small form factor PCs (especially for HTPCs) with dimensions of 8 × 9.6 inches (203 × 244 mm). [2]
In traditional systems over-pressure is dealt with through relief systems. A relief system will open an alternative outlet for the fluids in the system once a set pressure is exceeded, to avoid further build-up of pressure in the protected system. This alternative outlet generally leads to a flare or venting system to safely dispose the excess ...
The total volume of the tank is V t. Case 2 is a tank in use, with the air pressure at pressure P (gauge) and a water volume of V. Referring to the diagram on the right, a pressure tank is generally pressurized when empty with a "charging pressure" P c, which is usually about 2 psi below the turn-on pressure P lo (Case 1).