Ads
related to: portable water air cooler pump watts chart for refrigerator making
Search results
Results From The WOW.Com Content Network
As the target temperature of the refrigerator approaches ambient temperature, without exceeding it, the refrigeration capacity increases thus increasing the refrigerator's COP. The SI unit is watt (W). Another unit common in non-metric regions or sectors is the ton of refrigeration, which describes the amount of water at freezing temperature ...
An evaporative cooler (also known as evaporative air conditioner, swamp cooler, swamp box, desert cooler and wet air cooler) is a device that cools air through the evaporation of water. Evaporative cooling differs from other air conditioning systems, which use vapor-compression or absorption refrigeration cycles.
State-of-the-art AWG for home use. An atmospheric water generator (AWG), is a device that extracts water from humid ambient air, producing potable water. Water vapor in the air can be extracted either by condensation - cooling the air below its dew point, exposing the air to desiccants, using membranes that only pass water vapor, collecting fog, [1] or pressurizing the air.
Common absorption refrigerators use a refrigerant with a very low boiling point (less than −18 °C (0 °F)) just like compressor refrigerators.Compression refrigerators typically use an HCFC or HFC, while absorption refrigerators typically use ammonia or water and need at least a second fluid able to absorb the coolant, the absorbent, respectively water (for ammonia) or brine (for water).
A water dispenser, sometimes referred to as a water cooler (if used for cooling only), is a machine that dispenses and often also cools or heats up water with a refrigeration unit. It is commonly located near the restroom due to closer access to plumbing. A drain line is also provided from the water cooler into the sewer system.
A representative pressure–volume diagram for a refrigeration cycle. Vapour-compression refrigeration or vapor-compression refrigeration system (VCRS), [1] in which the refrigerant undergoes phase changes, is one of the many refrigeration cycles and is the most widely used method for air conditioning of buildings and automobiles.
A pot-in-pot refrigerator, clay pot cooler [1] or zeer (Arabic: زير) is an evaporative cooling refrigeration device which does not use electricity. It uses a porous outer clay pot (lined with wet sand) containing an inner pot (which can be glazed to prevent penetration by the liquid) within which the food is placed.
The coefficient of performance or COP (sometimes CP or CoP) of a heat pump, refrigerator or air conditioning system is a ratio of useful heating or cooling provided to work (energy) required. [ 1 ] [ 2 ] Higher COPs equate to higher efficiency, lower energy (power) consumption and thus lower operating costs.