Search results
Results From The WOW.Com Content Network
It is also known as short-circuit test (because it is the mechanical analogy of a transformer short-circuit test), [1] locked rotor test or stalled torque test. [2] From this test, short-circuit current at normal voltage , power factor on short circuit, total leakage reactance , and starting torque of the motor can be found.
The complete engine assembly from fan to flywheel and all auxiliaries weighed in at 460 lb, around 12% less than the design target, while net output for the higher compression (9.0:1) version fitted with a 2-barrel carburettor [b] was 185 hp (138 kW) with 262 lb.ft of torque, which matched or exceeded the targets set for the larger 308. The ...
In an electric power system, a fault or fault current is any abnormal electric current. For example, a short circuit is a fault in which a live wire touches a neutral or ground wire. An open-circuit fault occurs if a circuit is interrupted by a failure of a current-carrying wire (phase or neutral) or a blown fuse or circuit breaker.
These can manifest only at specific environmental conditions, high clock speeds, low power supply voltages, and sometimes specific circuit signal states; significant variations can occur on a single die. [9] Overstress-induced damage like ohmic shunts or a reduced transistor output current can increase such delays, leading to erratic behavior.
Diagram of a simple circuit with an inductance L and a flyback diode D.The resistor R represents the resistance of the inductor's windings. A flyback diode is any diode connected across an inductor used to eliminate flyback, which is the sudden voltage spike seen across an inductive load when its supply current is suddenly reduced or interrupted.
Circuit-breakers can be placed at portions of a circuit in series to the path of current it will affect. If more current than expected goes through the circuit-breaker, the circuit breaker "opens" the circuit and stops all current. A fuse is a common type of circuit breaker that involves direct effect of Joule-overheating.
A switched-mode power supply will be affected if the brownout voltage is lower than the minimum input voltage of the power supply. As the input voltage falls, the current draw will increase to maintain the same output voltage and current, until such a point that the power supply malfunctions or its under-voltage protection kicks in and disables ...
If circuit 2 is an audio system and circuit 1 has large AC currents flowing in it, the interference may be heard as a 50 or 60 Hz hum in the speakers. Also, both circuits have voltage on their grounded parts that may be exposed to contact, possibly presenting a shock hazard. This is true even if circuit 2 is turned off.