Search results
Results From The WOW.Com Content Network
In the oil industry, mud weight is the density of the drilling fluid and is normally measured in pounds per gallon (lb/gal) (ppg) or pound cubic feet (pcf) . [1] In the field it is measured using a mud scale or mud balance. Mud can weigh up to 22 or 23 ppg. A gallon of water typically weighs 8.33 pounds (or 7.48 ppg).
Drilling fluids also support portion of drill-string or casing through buoyancy. Suspend in drilling fluid, buoyed by force equal to weight (or density) of mud, so reducing hook load at derrick. Weight that derrick can support limited by mechanical capacity, increase depth so weight of drill-string and casing increase.
Feet of pipe (ft) = Volume of mud (bbls) / Capacity (bbls/ft) Capacity calculation is important in oil well control due to the following: Volume of the drillpipe and the drill collars must be pumped to get kill weight mud to the bit during kill operation. It is used to spot pills and plugs at various depths in the wellbore. [26]
P = 0.052 * mud weight * true vertical depth. taught in almost all petroleum engineering courses worldwide, the mud weight (MW) is expressed in pounds per U.S. gallon, and the true vertical depth (TVD) is expressed in feet, and 0.052 is a commonly used conversion constant that can be derived by dimensional analysis:
Mishandling mud at the surface accounts for many instances of insufficient fluid weight. Such as opening the wrong valve on the pump suction manifold and allowing a tank of lightweight fluid to be pumped; bumping the water valve so more is added than intended; washing off shale shakers; or clean-up operations. All of these can affect mud weight.
This mud type can be used as a completion and workover fluid, a spotting fluid to relieve a stuck pipe and as packer or casing fluid. They are very good for "Gumbo" shales. The mud weight can be controlled from 7–22 lbs/gal. It is sensitive to temperature but does not dehydrate as in the case of water based mud as mentioned before.
A mud balance, also known as a mud scale is a device used to measure the density (weight) of drilling fluid, [1] cement [2] or any type of liquid or slurry.
When underbalanced drilling is used, mud pulse telemetry can become unusable. This is usually because, in order to reduce the equivalent density of the drilling mud, a compressible gas is injected into the mud. This causes high signal attenuation which drastically reduces the ability of the mud to transmit pulsed data. In this case, it is ...