Search results
Results From The WOW.Com Content Network
The tire diameter is given for High Flotation tires and omitted from Numeric tires. 2-digit number: The diameter of the tire in inches. x: Separator character. 3- or 4-digit number: The section width (cross-section) of the tire in inches. If the tire diameter is not given, section widths ending in zero (e.g., 7.00 or 10.50) indicate the aspect ...
The inner width of the rim on which the tire is mounted should be about 65% of the tire's nominal section width for tires smaller than 30 mm and 55% for those larger. The section height of a tire is usually identical to its section width (for tires less than 28 mm, 2.5 mm have to be added to the width to get the height).
For passenger and light truck tyres, the manufacturers or importers have the choice of either putting a sticker on the tyre tread or a label accompanying each delivery of batch of tyres to the dealer and to the end consumer. The tyre label will use a classification from the best (green category "A") to the worst performance (red category "G").
Another example is part marking locations. An area for part identification marking can be circled on a top view but assigned to either the top or bottom of the part simply with a "near side" or "far side" notation—which obviates adding any otherwise-unneeded bottom view to the field of the drawing. FSCM: Federal Stock/Supply Code for ...
Tire uniformity refers to the dynamic mechanical properties of pneumatic tires as strictly defined by a set of measurement standards and test conditions accepted by global tire and car makers. These standards include the parameters of radial force variation , lateral force variation , conicity, ply steer, radial run-out , lateral run-out , and ...
ETRTO sizes apply to rims and tyres for vehicles of all types, including bicycles. The great advantage of ETRTO sizing is that it is unambiguous; previously, nominal dimensions were used which were interpreted in different ways by different countries and manufacturers - a problem for the end user.
Cutaway diagram of a rim and tire from an ATV Cross section of a bicycle rim A wooden bicycle rim with tubular tire. The rim is the "outer edge of a wheel, holding the tire". [1] It makes up the outer circular design of the wheel on which the inside edge of the tire is mounted on vehicles such as automobiles. [2]
Skid marks are divided into "acceleration marks" created on acceleration, if the engine provides more power than the tire can transmit; "braking marks", if the brakes "lock up" and cause the tire to slide; or "yaw marks", if the tire slides sideways. Each skid mark has a characteristic appearance, and an experienced accident reconstructor or ...