Ads
related to: ipv4 vs ipv6 cisco router
Search results
Results From The WOW.Com Content Network
There is a difference between a "relay router" and a "border router" (also known as a "6to4 border router"). A 6to4 border router is an IPv6 router supporting a 6to4 pseudo-interface. It is normally the border router between an IPv6 site and a wide-area IPv4 network, where the IPv6 site uses 2002:: / 16 co-related to the IPv4 address used later ...
An IPv6 transition mechanism is a technology that facilitates the transitioning of the Internet from the Internet Protocol version 4 (IPv4) infrastructure in use since 1983 to the successor addressing and routing system of Internet Protocol Version 6 (IPv6). As IPv4 and IPv6 networks are not directly interoperable, transition technologies are ...
NAT64 is an IPv6 transition mechanism that facilitates communication between IPv6 and IPv4 hosts by using a form of network address translation (NAT). The NAT64 gateway is a translator between IPv4 and IPv6 protocols, [1] for which function it needs at least one IPv4 address and an IPv6 network segment comprising a 32-bit address space.
This is a list of the IP protocol numbers found in the field Protocol of the IPv4 header and the Next Header field of the IPv6 header. It is an identifier for the encapsulated protocol and determines the layout of the data that immediately follows the header. Both fields are eight bits wide.
In IPv4, this function was placed at the Internet Layer and is performed in IPv4 routers limiting exposure to these issues by hosts. In contrast, IPv6, the next generation of the Internet Protocol, does not allow routers to perform fragmentation; hosts must perform Path MTU Discovery before sending datagrams.
A previous format, called "IPv4-compatible IPv6 address", was ::192.0.2.128; however, this method is deprecated. [36] Because of the significant internal differences between IPv4 and IPv6 protocol stacks, some of the lower-level functionality available to programmers in the IPv6 stack does not work the same when used with IPv4-mapped addresses.
The Cisco multicast router AUTO-RP-ANNOUNCE address is used by RP mapping agents to listen for candidate announcements. Yes 224.0.1.40 The Cisco multicast router AUTO-RP-DISCOVERY address is the destination address for messages from the RP mapping agent to discover candidates. Yes 224.0.1.41 H.323 Gatekeeper discovery address Yes 224.0.1.129–132
Port Control Protocol (PCP) is a computer networking protocol that allows hosts on IPv4 or IPv6 networks to control how the incoming IPv4 or IPv6 packets are translated and forwarded by an upstream router that performs network address translation (NAT) or packet filtering.