Ads
related to: replacement jacket hood for stove burner pipe cleaner parts diagram
Search results
Results From The WOW.Com Content Network
A kitchen hood in a small apartment. A kitchen hood, exhaust hood, hood fan, extractor hood, or range hood is a device containing a mechanical fan that hangs above the stove or cooktop in the kitchen. It removes airborne grease, combustion products, fumes, smoke, heat, and steam from the air by evacuation of the air and filtration. [1]
A Kelly Kettle in use. Note the cork stopper is not in the water spout while water is being boiled, this is for safety reasons. Kelly Kettle, Storm Kettle, Ghillie Kettle, Thermette, Survival Kettle and Volcano Kettle are trade names for portable devices for boiling water outdoors using twigs and other small combustible materials; these devices consist of a water jacket surrounding a fire ...
Pipe cleaners are usually made two at a time, as the inner wires of each pipe cleaner have the yarn wrapped around them, making a coil, the outer wires trap the wraps of yarn, which are then cut, making the tufts. Chenille yarn is made in much the same way, which is why craft pipe cleaners are often called "chenille stems". The word "chenille ...
Water jackets were used to cool the barrels of machine guns until several years after the First World War, but modern machine guns are air-cooled to conserve weight and hence increase portability. In a reciprocating piston internal combustion engine , the water jacket is a series of holes either cast or bored through the main engine block and ...
The Teclu burner provides better mixing of air and fuel and can achieve higher flame temperatures than the Bunsen burner. [9] [10] Meker burner – The lower part of its tube has more openings with larger total cross-section, admitting more air and facilitating better mixing of air and gas. The tube is wider and its top is covered with a wire grid.
It is also known as a burner, burner can, combustion chamber or flame holder. In a gas turbine engine, the combustor or combustion chamber is fed high-pressure air by the compression system. The combustor then heats this air at constant pressure as the fuel/air mix burns. As it burns the fuel/air mix heats and rapidly expands.
A cowl is a usually hood-shaped covering used to increase the draft of a chimney and prevent backflow. The cowl, usually made of galvanized iron, is fitted to the chimney pot to prevent wind blowing the smoke back down into the room below.
The hood unit evolved from the switcher locomotive. A switcher's long hood is normally low enough that the crew can see over it, and there typically is no short hood. Alco introduced the road switcher concept with the RS-1, which was an enlarged switcher with a short hood ahead of the cab. This was added to provide protection for the crew in ...