Search results
Results From The WOW.Com Content Network
This example, from an Airbus A380, combines a pitot tube (right) with a static port and an angle-of-attack vane (left). Air-flow is right to left. Types of pitot tubes A pitot-static tube connected to a manometer Pitot tube on Kamov Ka-26 helicopter A Formula One car during testing with frames holding many pitot tubes Location of pitot tubes on ...
Examples of pitot tube, static tube, and pitot–static tube Static ports fitted to an Airbus A330 passenger airliner. The pitot–static system of instruments uses the principle of air pressure gradient. It works by measuring pressures or pressure differences and using these values to assess the speed and altitude. [1]
A pitot tube is used to measure fluid flow velocity. The tube is pointed into the flow and the difference between the stagnation pressure at the tip of the probe and the static pressure at its side is measured, yielding the dynamic pressure from which the fluid velocity is calculated using Bernoulli's equation. A volumetric rate of flow may be ...
Indicated airspeed measured by pitot-tube can be approximately expressed by the following equation delivered from Bernoulli's equation. () NOTE: The above equation applies only to conditions that can be treated as incompressible. Liquids are treated as incompressible under almost all conditions.
The pitot-static system comprises one or more pitot probes (or tubes) facing the on-coming air flow to measure pitot pressure (also called stagnation, total or ram pressure) and one or more static ports to measure the static pressure in the air flow. These two pressures are compared by the ASI to give an IAS reading.
The airspeed indicator (ASI), driven by ram air into a pitot tube and still air into a barometric static port, shows what is called indicated airspeed (IAS). The differential pressure is affected by air density. The ratio between the two measurements is temperature-dependent and pressure-dependent, according to the ideal gas law.
This video is an edited approach and landing of the Enterprise on Rogers Dry Lake. The air-to-air shot of the Space Shuttle at a few thousand feet above the lakebed, gives some idea of the steepness required for a Shuttle approach; also note the long pitot tube (an appendage used only for flight testing) extending from the Space Shuttle nose. 1977.
A flow of air through a pitot tube Venturi meter, showing the columns connected in a manometer and partially filled with water. The meter is "read" as a differential pressure head in cm or inches of water. Video of a Venturi meter used in a lab experiment Idealized flow in a Venturi tube