Ads
related to: random antenna wire lengths table
Search results
Results From The WOW.Com Content Network
Often random wire antennas are also (inaccurately) referred to as long-wire antennas.There is no accepted minimum size, but actual long-wire antennas must be greater than at least a quarter-wavelength ( 1 / 4 λ) or perhaps greater than a half ( 1 / 2 λ) at the frequency the long wire antenna is used for, and even a half-wave may only be considered "long-ish" rather than "truly ...
Assuming the building is about 20 feet tall, the length of wire seems to be on the order of 100 feet long – too short to be an HF Beverage antenna. Random wire antenna Moxon (1993) describes the random-wire antenna as an "odd bit of wire". [14] [page needed] It is the typical informal antenna erected for receiving shortwave and AM radio.
In electrical engineering, electrical length is a dimensionless parameter equal to the physical length of an electrical conductor such as a cable or wire, divided by the wavelength of alternating current at a given frequency traveling through the conductor. [1] [2] [3] In other words, it is the length of the conductor measured in wavelengths.
4 Random wire antenna used for transmitting avoids resonant lengths. 1 comment. Toggle the table of contents. Talk: Random wire antenna. Add languages.
Moxon antenna for the 20-meter band.The antenna is the faint rectangle of wires held in tension by the bent X-shaped support frame. Moxon antenna for the 2-meter band. The Moxon antenna or Moxon rectangle is a simple and mechanically rugged two-element parasitic array, single-frequency antenna. [1]
The length is not critical, typically from one to two wavelengths end-to-end, but for any given length and frequency, there is an optimum acute angle at which the sections should meet. A horizontal rhombic antenna radiates horizontally polarized radio waves at a low elevation angle off the acute end of the antenna opposite the feedline.