Search results
Results From The WOW.Com Content Network
A concrete girder bridge pier during construction prior to installation of the bridge deck and parapets, consisting of multiple angled pylons for support (bottom), a horizontal concrete cap (center), and girders (top) with temporary wood bracing A quadruple compound pier supporting the fly-over at the traffic junction 24 Oktoberplein (Utrecht ...
If the spandrel is solid, usually the case in a masonry or stone arch bridge, the bridge is called a closed-spandrel deck arch bridge. If the deck is supported by a number of vertical columns rising from the arch, the bridge is known as an open-spandrel deck arch bridge. The Alexander Hamilton Bridge is an example of an open-spandrel arch ...
The through arch bridge usually consists of two ribs, [5] although there are examples like the Hulme Arch Bridge of through arches with a single rib. When the two arches are built in parallel planes, the structure is a parallel rib arch bridge. When the two arch ribs lean together and shorten the distance between the arches near the top, the ...
In this case, the height of the structure, measured between the top of the deck and the ground, is between the values a/3 and a/2, where a denotes the span of the arch, which is generally a semicircular or elliptical arch. [7] The thickness e of the pier depends solely on the span of the arches: a/10 < e < a/8.
Because both the arch and the tie are mainly subject to axial forces, their cross sections can be very small. Usually, transverse bending in the deck is bigger than bending in longitudinal direction. Therefore, a concrete deck that spans between the arches is a good solution for bridges with arch distances that are not too large.
The single arch of the bridge has a span of 31.4 meters and a rise of 11.42 meters, which was unusually flat for the time. The structure features two different masonry techniques: the lower part is made of gneiss blocks, dry-laid, while the upper part is a superposition of layers made of gneiss flakes and lime, interspersed with bands of stone. [9]
A fixed arch bridge, that is one without hinges, exerts a bending moment at the abutments and stresses caused by change of temperature or shrinkage of concrete have to be taken up by the arch. A two-hinged arch has a hinge at the base of each arch (the springing point), while a three-hinged arch has a third hinge at the crown of the arch. [3]
When a bridge deck is installed in a through truss, it is sometimes called a floor system. [1] A suspended bridge deck will be suspended from the main structural elements on a suspension or arch bridge. On some bridges, such as a tied-arch or a cable-stayed, the deck is a primary structural element, carrying tension or compression to support ...