Ads
related to: dell boot sequence add option to file system software required to connect
Search results
Results From The WOW.Com Content Network
The boot loader is responsible for accessing the file system on the boot drive, starting ntoskrnl.exe, and loading boot-time device drivers into memory. Once all the boot and system drivers have been loaded, the kernel starts the session manager (smss.exe), which begins the login process.
Prior to the development and ubiquitous adoption of the Plug and Play BIOS standard, an add-on device such as a hard disk controller or a network adapter card (NIC) was generally required to include an option ROM in order to be bootable, as the motherboard BIOS did not include any support for the device and so could not incorporate it into the BIOS's boot protocol.
Typically, the system firmware (UEFI or BIOS) will allow the user to configure a boot order. If the boot order is set to "first, the DVD drive; second, the hard disk drive", then the firmware will try to boot from the DVD drive, and if this fails (e.g. because there is no DVD in the drive), it will try to boot from the local hard disk drive.
provide a user interface for system's configuration; construct whatever system environment is required by the target operating system; In early BIOSes, POST did not organize or select boot devices, it simply identified floppy or hard disks, which the system would always try to boot in that order.
When a system on a chip (SoC) enters suspend to RAM mode, in many cases, the processor is completely off while the RAM is put in self refresh mode. At resume, the boot ROM is executed again and many boot ROMs are able to detect that the SoC was in suspend to RAM and can resume by jumping directly to the kernel which then takes care of powering on again the peripherals which were off and ...
The Windows boot manager is located at the \EFI\Microsoft\Boot\ subfolder of the EFI system partition. [23] On Windows XP 64-Bit Edition and later, access to the EFI system partition is obtained by running the mountvol command. Mounts the EFI system partition on the specified drive. Available on Itanium-based computers only. [24]
The system partition is the disk partition that contains the operating system folder, known as the system root. By default, in Linux, operating system files are mounted at / (the root directory). In Linux, a single partition can be both a boot and a system partition if both /boot/ and the root directory are in the same partition.
Pre-boot authentication can by performed by an add-on of the operating system like Linux Initial ramdisk or Microsoft's boot software of the system partition (or boot partition) or by a variety of full disk encryption (FDE) vendors that can be installed separately to the operating system. Legacy FDE systems tended to rely upon PBA as their ...