Search results
Results From The WOW.Com Content Network
Physical scientists often use the term root mean square as a synonym for standard deviation when it can be assumed the input signal has zero mean, that is, referring to the square root of the mean squared deviation of a signal from a given baseline or fit. [8] [9] This is useful for electrical engineers in calculating the "AC only" RMS of a signal.
Continuous charge distribution. The volume charge density ρ is the amount of charge per unit volume (cube), surface charge density σ is amount per unit surface area (circle) with outward unit normal nĚ‚, d is the dipole moment between two point charges, the volume density of these is the polarization density P.
In electronics and electrical engineering, the form factor of an alternating current waveform (signal) is the ratio of the RMS (root mean square) value to the average value (mathematical mean of absolute values of all points on the waveform). [1] It identifies the ratio of the direct current of equal power relative to the given alternating ...
root mean square The root mean square value of a waveform is the DC value that corresponds to equivalent heating value. rotary converter An electric machine that converts electric power between two forms, say, AC and DC or single-phase and three phase, or between two different frequencies of AC (the latter two can be performed by the same machine).
In fluid dynamics, normalized root mean square deviation (NRMSD), coefficient of variation (CV), and percent RMS are used to quantify the uniformity of flow behavior such as velocity profile, temperature distribution, or gas species concentration. The value is compared to industry standards to optimize the design of flow and thermal equipment ...
The root-mean-square value of the shot noise current i n is given by the Schottky formula. i n = 2 I q Δ B {\displaystyle i_{n}={\sqrt {2Iq\Delta B}}} where I is the DC current, q is the charge of an electron, and Δ B is the bandwidth in hertz.
An electronic symbol is a pictogram used to represent various electrical and electronic devices or functions, such as wires, batteries, resistors, and transistors, in a schematic diagram of an electrical or electronic circuit. These symbols are largely standardized internationally today, but may vary from country to country, or engineering ...
Reference should be made to codes and standards. For example, IEC 60027, and Letter Symbols in Electrical Technology. Here are tables of widely accepted symbols. They are meant to be a guideline: Using the same symbols for the same things in different articles will increase their consistency, making them easier to understand and to improve.