Search results
Results From The WOW.Com Content Network
The Gaussian function has a 1/e 2 diameter (2w as used in the text) about 1.7 times the FWHM.. At a position z along the beam (measured from the focus), the spot size parameter w is given by a hyperbolic relation: [1] = + (), where [1] = is called the Rayleigh range as further discussed below, and is the refractive index of the medium.
In optics, the complex beam parameter is a complex number that specifies the properties of a Gaussian beam at a particular point z along the axis of the beam. It is usually denoted by q . It can be calculated from the beam's vacuum wavelength λ 0 , the radius of curvature R of the phase front , the index of refraction n ( n =1 for air), and ...
In laser science, the parameter M 2, also known as the beam propagation ratio or beam quality factor is a measure of laser beam quality. It represents the degree of variation of a beam from an ideal Gaussian beam. [1] It is calculated from the ratio of the beam parameter product (BPP) of the beam to that of a Gaussian beam with the same wavelength.
Gaussian beam width () as a function of the axial distance .: beam waist; : confocal parameter; : Rayleigh length; : total angular spread In optics and especially laser science, the Rayleigh length or Rayleigh range, , is the distance along the propagation direction of a beam from the waist to the place where the area of the cross section is doubled. [1]
This function is known as a super-Gaussian function and is often used for Gaussian beam formulation. [5] This function may also be expressed in terms of the full width at half maximum (FWHM), represented by w : f ( x ) = A exp ( − ln 2 ( 4 ( x − x 0 ) 2 w 2 ) P ) . {\displaystyle f(x)=A\exp \left(-\ln 2\left(4{\frac {(x-x_{0})^{2 ...
By observing and recording the beam pattern, for example, one can infer the spatial mode properties of the beam and whether or not the beam is being clipped by an obstruction; By focusing the laser beam with a lens and measuring the minimum spot size, the number of times diffraction limit or focusing quality can be computed.
To calculate the optical broad-beam response, the impulse response of a pencil beam is convolved with the beam function. As shown by Equation 4, this is a 2-D convolution. To calculate the response of a light beam on a plane perpendicular to the z axis, the beam function (represented by a b × b matrix) is convolved with the impulse response on ...
A Gaussian beam has the lowest possible BPP, /, where is the wavelength of the light. [1] The ratio of the BPP of an actual beam to that of an ideal Gaussian beam at the same wavelength is denoted M 2 ("M squared"). This parameter is a wavelength-independent measure of beam quality.