When.com Web Search

  1. Ads

    related to: installing tongue and groove boards exterior house

Search results

  1. Results From The WOW.Com Content Network
  2. Matchboard - Wikipedia

    en.wikipedia.org/wiki/Matchboard

    Matchboard by definition is "a board with a groove cut along one edge and a tongue along the other so as to fit snugly with the edges of similarly cut boards." [1]Bramble Cottage on Lundy Island, weathered cedar matchboarding in an exposed location

  3. Tongue and groove - Wikipedia

    en.wikipedia.org/wiki/Tongue_and_groove

    Tongue and groove joints allow two flat pieces to be joined strongly together to make a single flat surface. Before plywood became common, tongue and groove boards were also used for sheathing buildings and to construct concrete formwork. A strong joint, the tongue and groove joint is widely used for re-entrant angles

  4. Douglas House (Harbor Springs, Michigan) - Wikipedia

    en.wikipedia.org/wiki/Douglas_House_(Harbor...

    The overall form of the house is a large rectangle set on end. [3] The rear wall of the house, which faces the lake, makes extensive use of glass to provide maximum views. The house is built of redwood (vertical Tongue and Groove boards) and is almost completely white. [7] The foundation consists of a series of pilings hammered into the earth.

  5. American historic carpentry - Wikipedia

    en.wikipedia.org/wiki/American_historic_carpentry

    Sometimes there are studs at the doors but mostly the vertical planks replace the studs. Both wood shingle or clapboard exterior siding and interior lath and plaster attach directly to the planks. [10] Some examples of plank frame houses are the oldest house in New Hampshire, the Richard Jackson House, Thomas and Esther Smith House in ...

  6. Joinery - Wikipedia

    en.wikipedia.org/wiki/Joinery

    Tongue and groove: Each piece has a groove cut all along one edge, and a thin, deep ridge (the tongue) on the opposite edge. If the tongue is unattached, it is considered a spline joint. Birdsmouth joint: Also called a bird's beak cut, this joint used in roof construction. A V-shaped cut in the rafter connects the rafter to the wall-plate. [11 ...

  7. Frame and panel - Wikipedia

    en.wikipedia.org/wiki/Frame_and_panel

    A flat panel has its visible face flush with the front of the groove in the frame. This gives the panel an inset appearance. This style of panel is commonly made from man-made materials such as MDF or plywood but may also be made from solid wood or tongue and groove planks. Panels made from MDF will be painted to hide their appearance, but ...