When.com Web Search

  1. Ads

    related to: switch step in snowboard bindings and boots package

Search results

  1. Results From The WOW.Com Content Network
  2. Ski boot - Wikipedia

    en.wikipedia.org/wiki/Ski_boot

    Snowboard boots and bindings are normally far simpler than their downhill counterparts, rarely including release systems for instance, and need to provide mechanical support only in the fore and aft directions. These typically consist of an external frame, generally L-shaped, which the snowboarder steps into and then fastens down using straps ...

  3. Snowboard binding rotating device - Wikipedia

    en.wikipedia.org/wiki/Snowboard_binding_rotating...

    Snowboard boot bindings are normally screwed onto the snowboard in a permanent orientation which is almost perpendicular to the direction of travel of the snowboard. When a snowboarder reaches the bottom of a run, the rear boot is typically released from its binding to allow the snowboarder to propel himself forward across relatively flat snow.

  4. Snowboard - Wikipedia

    en.wikipedia.org/wiki/Snowboard

    Snowboard, K2 Clicker step-in binding. Innovators of step-in systems produced prototypes and designed proprietary step-in boot and binding systems with the goal of improving the performance of snowboard boots and bindings, and as a result, the mid-90s saw an explosion of step-in binding and boot development.

  5. Ski binding - Wikipedia

    en.wikipedia.org/wiki/Ski_binding

    Alpine ski bindings have two functions: 1) Retaining the ski boot on the ski, 2) Releasing the ski boot from the ski in case of a fall to prevent injury to the skier. [11] The retention function typically involves stepping into the binding toe-first and pressing down with the heel of the ski boot, which causes a latch to engage the heel.

  6. Look Nevada - Wikipedia

    en.wikipedia.org/wiki/Look_Nevada

    The actual binding point was a bronze roller sized to be similar to a standard cable, this could clip on top of the heel, or would fit into the indentation cut into the heel of some boots. The Grand Prix offered step-in convenience; to put the binding on, the skier inserted their toe under the Nevada II, then stepped down at the heel.

  7. Burton Snowboards - Wikipedia

    en.wikipedia.org/wiki/Burton_Snowboards

    Burton Snowboards is a privately-owned snowboard manufacturing company that was founded by Jake Burton Carpenter in 1977. [ 2 ] [ 3 ] The company specializes in products aimed at snowboarders , such as snowboards, bindings , boots , outerwear, and accessories.