When.com Web Search

  1. Ads

    related to: large hole punch for metal with sight hole machine for reloading

Search results

  1. Results From The WOW.Com Content Network
  2. Turret punch - Wikipedia

    en.wikipedia.org/wiki/Turret_punch

    A turret punch or turret press is a type of punch press used for metal forming by punching. Punching, and press work in general, is a process well suited to mass production. However the initial tooling costs, of both the machine and the job-specific press tool, are high. This limits punch work from being used for much small-volume and prototype ...

  3. Automatic center punch - Wikipedia

    en.wikipedia.org/wiki/Automatic_center_punch

    The Adell and Starrett mechanism uses a sliding block crosswise through the hammer rather than an intermediate pin. The hammer has a hole through its center that the top of the punch sits in, and holds the top of the punch centered. The sliding block has a hole through it that, when reset, is misaligned with the hole through the hammer.

  4. Knockout punch - Wikipedia

    en.wikipedia.org/wiki/Knockout_punch

    Chassis punches: assorted sizes round and square Chassis punches: assorted sizes round and square disassembled. In metalworking, a knockout punch, also known as a chassis punch, panel punch, Greenlee punch, or a Q-max, [1] is a hand tool used to punch a hole through sheet metal. It is a very simple tool that consists of a punch, die, and screw.

  5. Punch press - Wikipedia

    en.wikipedia.org/wiki/Punch_press

    A punch press is a type of machine press used to cut holes in material. It can be small and manually operated and hold one simple die set, or be very large, CNC operated, with a multi-station turret and hold a much larger and complex die set.

  6. Punching - Wikipedia

    en.wikipedia.org/wiki/Punching

    It is the most cost effective process of making holes in strip or sheet metal for average to high fabrication. It is able to create multiple shaped holes. Punches and dies are usually fabricated from conventional tool steel or carbides; It creates a burnished region roll-over, and die break on sidewall of the resulting hole. [1] It is a quick ...

  7. Punch (tool) - Wikipedia

    en.wikipedia.org/wiki/Punch_(tool)

    A center punch forms a large enough dimple to "guide" the tip of the drill. The tip of a center punch has an angle between 60 and 90 degrees. [1] When drilling larger holes, where the drill bit is wider than the indentation produced by a center punch, the drilling of a pilot hole is usually needed.