When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Automatic center punch - Wikipedia

   en.wikipedia.org/wiki/Automatic_center_punch

   An automatic center punch is a hand tool used to produce a dimple in a workpiece (for example, a piece of metal). It performs the same function as an ordinary center punch but without the need for a hammer. When pressed against the workpiece, it stores energy in a spring, eventually releasing it as an impulse that drives the punch, producing ...

3. Knockout punch - Wikipedia

   en.wikipedia.org/wiki/Knockout_punch

   The screw is then threaded into the punch and the screw tightened until the punch is drawn completely through the sheet metal. [2] The manual system uses a screw that has a standard hex head or square head and is driven using an allen key or wrench. A manual knockout punch can handle holes from 0.5 to 1.25 in (13 to 32 mm).

4. Punch (tool) - Wikipedia

   en.wikipedia.org/wiki/Punch_(tool)

   A center punch is used to mark the center of a point. It is usually used to mark the center of a hole when drilling holes. A drill has the tendency to "wander" if it does not start in a recess. A center punch forms a large enough dimple to "guide" the tip of the drill. The tip of a center punch has an angle between 60 and 90 degrees. [1]

5. Types of press tools - Wikipedia

   en.wikipedia.org/wiki/Types_of_press_tools

   The compound tool differs from progressive and stage tools by the arrangement of the punch and die. It is an inverted tool where blanking and piercing takes place in a single stage and also the blanking punch will act as the piercing die. That means punch will be to the bottom side of the tool and piercing punches to top side of the tool.

6. Blanking and piercing - Wikipedia

   en.wikipedia.org/wiki/Blanking_and_piercing

   This allows for complex shapes to be formed in sheet metal up to 6 mm (0.25 in) thick using simple tools. [4] that is essentially a small punch and die that reciprocates quickly; around 300–900 times per minute. Punches are available in various shape and sizes; oblong and rectangular punches are common because they minimize waste and allow ...

7. Punching - Wikipedia

   en.wikipedia.org/wiki/Punching

   The punch force required to punch a piece of sheet metal can be estimated from the following equation: [4] F = 0.7 t L ( U T S ) {\displaystyle F=0.7tL(UTS)} Where t is the sheet metal thickness, L is the total length sheared (perimeter of the shape), and UTS is the ultimate tensile strength of the material.