Ads
related to: np205 transfer case yokes
Search results
Results From The WOW.Com Content Network
All but the M1028A1 and M1031 used the NP-208 chain drive transfer case. The M1028A1 and M1031 units had a slip-yoke rear output version of the NP-205, which was specified mainly for its PTO capacity. The CUCV series had a governed top speed of 55 mph (89 km/h). [15]
The Syracuse New Process Gear plant produced transfer cases for all of the "Big Three"—Ford, Chrysler, and General Motors. The NV247 all-wheel drive transfer case, sold by Chrysler's Jeep division as the "Quadra-Trac II," the manual transaxle for the Dodge Neon and PT Cruiser (T-350), and manual transaxles for European-export Chrysler ...
Starting in 1981 used the chain-driven NP208 transfer case (NP241 after 1988) with front 10-bolt/rear 10-bolt axle combinations until 1991. There is an overlap of 12-bolt rears into the early 1980s, while the 10-bolt front axle was phased into production in the late 1970s.
The switch controls the 4WD mode with options of 2WD - 4WD Auto - N - 4WD Low. The MP3022 transfer case uses an electronically controlled clutch pack to bias torque from 100% rear to 50/50% front/rear. The transfer case has no center differential, so power can only be supplied to the front axle when the rear wheels begin to slip.
A transfer case is an intermediate gearbox that transfers power from the transmission of a motor vehicle to the driven axles of four-wheel-drive, all-wheel-drive, and other multi-axled on- and off-road machines.
It looks similar to and could be mistaken for the Dodge NV3500. However the Jeep NV3550 bellhousing bolts to the transmission case. There are four GM medium duty transmission designs that led to and are often mistaken for the NV3500: 1987 MG-290 MG= Muncie Gear; 1988 HM-290 HM= Hydramatic Muncie; 1989 5LM60 (early)