Ads
related to: bolt size and head chart for cars
Search results
Results From The WOW.Com Content Network
A few sizes are close enough to interchange for most purposes, such as 19 mm (close to 3 ⁄ 4 inch (19.05 mm)), 8 mm (close to 5 ⁄ 16 inch (7.94 mm)) and 4 mm (close to 5 ⁄ 32 inch (3.97 mm)). In reality, a wrench with a width across the flats of exactly 15 mm would fit too tightly to use on a bolt with a width across the flats of 15 mm.
British Standard Fine (BSF) is a screw thread form, as a fine-pitch alternative to British Standard Whitworth (BSW) thread. It was used for steel bolts and nuts on and in much of Britain's machinery, including cars, prior to adoption of Unified, and later Metric, standards.
To simplify matters, the term hexagon is used in this section to denote either bolt head or nut. Two spanners, both nominal size 5 ⁄ 8 in, with a diagram superimposed to show the logic that allows them both to be nominal size 5 ⁄ 8 in when their actual sizes are clearly different (across-flats distance vs screw diameter). The across-flats ...
The major diameter is given by 6p 1.2, [4]: 12 rounded to two significant figures in mm and the hex head size (across the flats) is 1.75 times the major diameter. BA sizes are specified by the following British Standards: BS 57:1951 — B.A. screws, bolts and nuts
1.2/1.3/1.5/1.7L were mostly in European Cars. 1.8, 2.0/2.3 had the same bellhousings bolt patterns with differences from year to year to be wary of. The Mazda transmission 5M** does not "directly replace" the Mitsubishi transmissions as there are shifter spacing differences in the floorboard.
For example, compare the 6–32, 8–32, 10–24, and 10–32 options in this table with the UTS versions of those sizes, which are not identical but are so close that interchange would work. Survey results on the use of SAE standards (including screw size standards), reported in the journal Horseless Age, 1916