Ads
related to: weep hole manufacturer
Search results
Results From The WOW.Com Content Network
Weep hole. A weep, a weep hole, or a weep-brick is a small opening that allows water to drain from within an assembly. Weeps are located at the bottom of the object to allow for drainage; the weep hole must be sized adequately to overcome surface tension.
Usually, weep holes are created by leaving out mortar at the vertical joints between bricks at regular intervals, by the insertion of tubes, or by inserting an absorbent wicking material into the joint. Weep holes are placed wherever a cavity is interrupted by a horizontal element, such as door or window lintels, masonry bearing angles, or slabs.
The Boston area experienced 62 "events" in 2021 (down from 212 in 2018). As of 2022, local utility company Eversource is replacing 38,000 maintenance hole covers, starting in high-traffic areas, with a safer design. A rail allows the cover to lift up to 4 inches (100 mm) and let gases escape, but prevents it from flying into the air and ...
Because the masonry veneer is non-structural, it must be tied back to the building structure to prevent movement under wind and earthquake loads. Brick ties are used for this purpose, and may take the form of corrugated metal straps nailed or screwed to the structural framing, or as wire extensions to horizontal joint reinforcement in a fully masonry veneer or cavity wall.
A diagram of a traditional French drain. A French drain [1] (also known by other names including trench drain, blind drain, [1] rubble drain, [1] and rock drain [1]) is a trench filled with gravel or rock, or both, with or without a perforated pipe that redirects surface water and groundwater away from an area.
In areas where the air or surface ground temperatures reach below freezing point for part or all of the year, some standpipes are equipped with a feature whereby the same mechanism that valves the water for the bib also uncovers a drainage hole (the 'weep hole') at the base of the pipe when the standpipe is closed, ensuring that the column of water drains into the ground rather than remaining ...
The weld access hole or rat hole is a structural engineering technique in which a part of the web of an I-beam or T-beam is cut out at the end or ends of the beam. The hole in the web allows a welder to weld the flange to another part of the structure with a continuous weld the full width on both top and bottom sides of the flange. Without the ...
A mason laying a brick on top of the mortar Bridge over the Isábena river in the Monastery of Santa María de Obarra, masonry construction with stones. Masonry is the craft of building a structure with brick, stone, or similar material, including mortar plastering which are often laid in, bound, and pasted together by mortar.