Search results
Results From The WOW.Com Content Network
The BT Home Hub configuration software is compatible with both Macintosh and Windows operating systems, although use of this is optional and computers without the BT software will still be able to connect to the Hub and browse the Internet normally. The 4th generation of the BT Home Hub was released on 10 May 2013.
Then, the command ipconfig /renew is executed to request a new IP address. [ 3 ] [ 4 ] Where a computer is connected to a cable or DSL modem, it may have to be plugged directly into the modem network port to bypass the router, before using ipconfig /release and turning off the power for a period of time, to ensure that the old IP address is ...
A typical CMTS allows a subscriber's computer to obtain an IP address by forwarding DHCP requests to the relevant servers. This DHCP server returns, for the most part, what looks like a typical response including an assigned IP address for the computer, gateway/router addresses to use, DNS servers, etc.
NOTE: a RID is the highest logical (loopback) IP address configured on a router, if no logical/loopback IP address is set then the router uses the highest IP address configured on its active interfaces (e.g. 192.168.0.1 would be higher than 10.1.1.2). Usually the router with the second-highest priority number becomes the BDR.
Linux-based router project supporting a large set of layer-1 technologies (e.g. Ethernet LAN, Wireless LAN, ISDN, DSL, UMTS), layer-3 protocols and functionality (IPv4, IPv6, stateful packet filter), and various network-related functionality (e.g. Bridging, Bonding, VLANs; DNS, DHCPv4, DHCPv6, IPv6 RA; PPP (client+server), PPTP (client+server ...
Users type in domain names, such as example.org, which the computer's DNS software looks up in the DNS databases to retrieve an IP address, and then hands off that address to the protocol stack for further communications. [5] Looking up an address using DNS requires the IP address of the DNS server to be known.
The primary function of a router is to forward a packet toward its destination network, which is the destination IP address of the packet. To do this, a router needs to search the routing information stored in its routing table. The routing table contains network/next hop associations. These associations tell a router that a particular ...
The route evaluation process in each router uses the longest prefix match method to obtain the most specific route. The network with the longest subnet mask or network prefix that matches the destination IP address is the next-hop network gateway. The process repeats until a packet is delivered to the destination host, or earlier along the ...