Ads
related to: water damaged hardwood floor replacement pads prices list philippines near
Search results
Results From The WOW.Com Content Network
An insurance policy may or may not cover the costs associated with water damage and the process of water damage restoration. While a common cause of residential water damage is often the failure of a sump pump, many homeowner's insurance policies do not cover the associated costs without an addendum which adds to the monthly premium of the policy.
Xanthostemon verdugonianus is known to be the hardest Philippine hardwood species. Cutting a 70-cm thick tree with axes normally requires three hours, but cutting a Mangkono tree with the same diameter usually takes two to four days. Diamond-point saws have been used exclusively but a great volume of water is needed to counter overheating. [1] [6]
Cork flooring is a flooring material manufactured from the by-product of the cork oak tree. Cork floors are considered to be eco-friendly since the cork oak tree bark is stripped every nine to ten years and doesn't damage the tree. Cork flooring comes in both tiles and planks, and can have glue or glues-less installation.
Trees were burned; rivers were certainly damaged. Proximate areas were also devastated by the eruption, with ash accumulating to 9 m (30 ft) in depth. In Albay, a total of 2,200 locals perished in what is considered to be the most lethal eruption in Mayon's history; estimates by PHIVOLCS list the casualties at about 1,200, however.
Coconut timber is a hardwood-substitute from coconut palm trees. It is referred to in the Philippines as coconut lumber, or coco lumber, and elsewhere additionally as cocowood [1] or red palm. [2] It is a new timber resource that comes from plantation crops and offers an alternative to rainforest timber.
Tempered hardboard is a hardboard that has been coated with a thin film of linseed oil and then baked; this gives it more water resistance, impact resistance, hardness, rigidity and tensile strength. An earlier tempering process involved immersing the board in linseed oil or tung oil until it was 5 to 6 percent saturated, and heating to 170 °C ...