When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Microphone connector - Wikipedia

   en.wikipedia.org/wiki/Microphone_connector

   Photo: 2.5 mm mono (TS), 3.5 mm mono and stereo (TRS), and 1 ⁄ 4 inch (6.4 mm) stereo (TRS) phone connectors The most common microphone connector in consumer use is the venerable phone connector, in 1 ⁄ 4 inch (6.4 mm), 3.5 mm, and 2.5 mm sizes, and in both mono and stereo configurations.

3. Berg connector - Wikipedia

   en.wikipedia.org/wiki/Berg_connector

   the four-pin polarized Berg connectors used to connect 3½-inch floppy disk drive units to the power supply unit, usually referred to as simply a "floppy power connector", but often also referred to as LP4. This connector has a 2.50 mm (0.098 in) pitch (not 2.54 mm).

4. Phone connector (audio) - Wikipedia

   en.wikipedia.org/wiki/Phone_connector_(audio)

   A two-pin version, known to the telecom industry as a "310 connector", consists of two 1 ⁄ 4-inch phone plugs at a centre spacing of 5 ⁄ 8 inch (16 mm). The socket versions of these can be used with normal phone plugs provided the plug bodies are not too large, but the plug version will only mate with two sockets at 5 ⁄ 8 inches centre ...

5. Modular connector - Wikipedia

   en.wikipedia.org/wiki/Modular_connector

   The height of the plug's insertion area is 0.260 inches (6.60 mm) and the contacts are 0.040 inches (1.02 mm) apart (contact pitch), so the width is dependent on the number of pin positions. [ 7 ] [ 8 ] However, not all plugs from all manufacturers have this capability, and some jack manufacturers warn that their jacks are not designed to ...

6. Coaxial power connector - Wikipedia

   en.wikipedia.org/wiki/Coaxial_power_connector

   There are a number of sizes listed below that appear to be quite similar, and while the tolerances of these connectors are typically indicated as ±0.05 or ±0.03 mm by the manufacturers, there is still ambiguity as to whether two sizes differing by only 0.05 mm (or where the specification is only given to the nearest 0.10 mm) warrants listing ...

7. DIN connector - Wikipedia

   en.wikipedia.org/wiki/DIN_connector

   Five-pin male 180° DIN connector from a 1988 Schneider MF2 keyboard by Cherry. The DIN connector is an electrical signal connector that was standardized by the Deutsches Institut für Normung (DIN), the German Institute for Standards, in the mid 1950s, initially with 3 pins for mono, but when stereo connections and gear appeared in late 1950s (1959 or so), versions with 5 pins or more were ...