Ads
related to: removing acetone under plating
Search results
Results From The WOW.Com Content Network
The definition used is quite different. In certain cases, these coverings may be desired: e.g. one may not wish to remove a paint layer but only the material on top. In another cases, where crack proofing is necessary, one has to remove the paint layer, as it is regarded as an unwanted substance.
Brush electroplating has several advantages over tank plating, including portability, the ability to plate items that for some reason cannot be tank plated (one application was the plating of portions of very large decorative support columns in a building restoration), low or no masking requirements, and comparatively low plating solution ...
Under appropriate conditions, these hydroxides condense with elimination of water to form a colloidal sol of very small particles, that are deposited as a hydrogel on the metal's surface. The gel consists of a three-dimensional solid skeleton of oxides and hydroxides, with nanoscale elements and voids, enclosing a liquid phase.
The optional second step (for bare silicon wafers) is a short immersion in a 1:100 or 1:50 solution of aqueous HF (hydrofluoric acid) at 25 °C for about fifteen seconds, in order to remove the thin oxide layer and some fraction of ionic contaminants. If this step is performed without ultra high purity materials and ultra clean containers, it ...
Electroless nickel immersion gold (ENIG or ENi/IAu), also known as immersion gold (Au), chemical Ni/Au or soft gold, is a metal plating process used in the manufacture of printed circuit boards (PCBs), to avoid oxidation and improve the solderability of copper contacts and plated through-holes.
One takes great care to remove any surface defects in the metal, like pits, that could allow bacteria to grow. A #4 dairy or sanitary finish is produced by polishing with a 180–240 grit belt or wheel finish softened with 120–240 grit greaseless compound or a fine non-woven abrasive belt or pad. #6 Finish. Also known as a fine satin finish.
The test surface is cleaned to remove any dirt, paint, oil, grease or any loose scale that could either keep penetrant out of a defect or cause irrelevant or false indications. Cleaning methods may include solvents, alkaline cleaning steps, vapour degreasing, or media blasting. The end goal of this step is a clean surface where any defects ...
Before plating, the surface of the material must be thoroughly cleaned. Unwanted solids left on the surface cause poor plating. Cleaning is usually achieved by a series of chemical baths, including non-polar solvents to remove oils and greases, as well as acids and alkalis to remove oxides, insoluble organics, and other surface contaminants.