Search results
Results From The WOW.Com Content Network
The DW-link uses anti-squat to eliminate "suspension bob." Squat is defined as the tendency of rear suspension to compress under acceleration. The anti-squat used in the DW-link system is achieved by a minimisation of torque about the centre of mass. The DW-link system has also been designed to minimise pedal feedback caused by suspension travel.
Schematic of a DCT (using two identical clutches located on the axis of the flywheel) A dual-clutch transmission (DCT) (sometimes referred to as a twin-clutch transmission) is a type of multi-speed vehicle transmission system, that uses two separate clutches for odd and even gear sets. [1]
A chain drive and rear derailleur gear change, the most popular system in use today A shaft-drive with crankset and rear gear hub. Bicycle drivetrain systems are used to transmit power on bicycles, tricycles, quadracycles, unicycles, or other human-powered vehicles from the riders to the drive wheels.
A single dwell linkage takes advantage of the behavior of a link with a stationary revolute (hinge) or prismatic (sliding) joint and its interaction with special coupler curves. There are two methods of producing a single-dwell: arc-based and linear-based. An arc-based single dwell linkage uses the approximation of a circular arc.
Watt's linkage automobile suspension Watt's linkage train suspension. Watt's linkage is used in the rear axle of some car suspensions as an improvement over the Panhard rod, which was designed in the early twentieth century. Both methods are intended to prevent relative sideways motion between the axle and body of the car.
A trailing-arm suspension, also referred to as trailing-link, is a form of vehicle suspension.In a motor vehicle it places one or more horizontal arms (or "links") perpendicular to and forward of the axle on the chassis or unibody, which are connected to the axle or wheels with pivot joint(s).
During the 1830s, the most popular valve drive for steam locomotives was known as gab motion in the United Kingdom and V-hook motion in the United States. [3] The gab motion incorporated two sets of eccentrics and rods for each cylinder; one eccentric was set to give forward and the other backwards motion to the engine and one or the other could accordingly engage with a pin driving the ...
A linkage between these hubs pivots the two wheels together, and by careful arrangement of the linkage dimensions the Ackermann geometry could be approximated. This was achieved by making the linkage not a simple parallelogram, but by making the length of the track rod (the moving link between the hubs) shorter than that of the axle, so that ...