Search results
Results From The WOW.Com Content Network
Router with two dozen 10 Gigabit Ethernet ports and three types of physical-layer module. 10 Gigabit Ethernet (abbreviated 10GE, 10GbE, or 10 GigE) is a group of computer networking technologies for transmitting Ethernet frames at a rate of 10 gigabits per second. It was first defined by the IEEE 802.3ae-2002 standard.
Some other computer architectures use different modules with a different bus width. In a single-channel configuration, only one module at a time can transfer information to the CPU. In multi-channel configurations, multiple modules can transfer information to the CPU at the same time, in parallel.
Supermicro AOC-SGP-I2 dual-port Gigabit Ethernet NIC, a PCI Express ×4 card. 1000BASE-T (also known as IEEE 802.3ab) is a standard for Gigabit Ethernet over twisted-pair wiring. Each 1000BASE-T network segment is recommended to be a maximum length of 100 meters (330 feet), [5] [a] and must use Category 5 cable or better (including Cat 5e and ...
The consumed bandwidth in bit/s, corresponds to achieved throughput or goodput, i.e., the average rate of successful data transfer through a communication path.The consumed bandwidth can be affected by technologies such as bandwidth shaping, bandwidth management, bandwidth throttling, bandwidth cap, bandwidth allocation (for example bandwidth allocation protocol and dynamic bandwidth ...
In computer networking, jumbo frames are Ethernet frames with more than 1500 bytes of payload, the limit set by the IEEE 802.3 standard. [1] The payload limit for jumbo frames is variable: while 9000 bytes is the most commonly used limit, smaller and larger limits exist.
The source sends the content to be displayed. Examples include set-top boxes, DVD, HD DVD and Blu-ray Disc players, and computer video cards. A source has only an HDCP/HDMI transmitter. [4] Sink The sink renders the content for display so it can be viewed. Examples include TVs and digital projectors.
Check the physical connection - A loose cable or cord can often be the cause of a connection problem. Make sure everything is securely connected to the wall and device. 3. Reboot your modem/router - Sometimes the old "turn it off and on again" approach actually does work! Just wait about five minutes before turning it back on to make sure ...
This solution works but causes some other problems. It is not passive any longer, so in the case of a failure the link can go down and the services on the link are interrupted. To minimize this problem each copper tap has a bypass switch (relays), which closes in a power down situation (as shown in the picture), to bring the link back up.