When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Choke manifold - Wikipedia

   en.wikipedia.org/wiki/Choke_manifold

   In oil and gas production a choke manifold is used to lower the pressure from the well head. It consist of a set of high pressure valves and at least two chokes. These chokes can be fixed or adjustable or a mix of both. The redundancy is needed so that if one choke has to be taken out of service, the flow can be directed through another one.

3. Choke valve - Wikipedia

   en.wikipedia.org/wiki/Choke_valve

   Most choke valves in engines are butterfly valves mounted upstream of the carburetor jet to produce a higher partial vacuum, which increases the fuel draw. [ 1 ] In heavy industrial or fluid engineering contexts, including oil and gas production, a choke valve or choke is a particular design of valve with a solid cylinder placed inside another ...

4. List of valves - Wikipedia

   en.wikipedia.org/wiki/List_of_valves

   Choke valve, Butterfly valve used to limit air intake in internal combustion engine. (Not to be confused with choke valves used in industrial flow control, above.) Clapper valve: a type of check valve used in the Siamese fire appliance to allow only one hose to be connected instead of two (the clapper valve blocks the other side from leaking out)

5. Separator (oil production) - Wikipedia

   en.wikipedia.org/wiki/Separator_(oil_production)

   The valves required for oil and gas separators are oil discharge control valve, water-discharge control valve (three-phase operation), drain valves, block valves, pressure relief valves, and emergency shutdown valves (ESD). ESD valves typically stay in open position for months or years awaiting a command signal to operate.

6. Gas–oil separation plant - Wikipedia

   en.wikipedia.org/wiki/Gas–oil_separation_plant

   The high pressure is reduced at the choke valve to typically 7 to 30 bar at the separator, although the first stage separator could operate at higher pressure c. 250 bar. [2] Modern oil recovery practice may place a hydro-cyclone to replace the temporary GOSP, allowing the water to be removed immediately and re-injected into the reservoir.

7. Cameron International - Wikipedia

   en.wikipedia.org/wiki/Cameron_International

   Cameron International Corporation (formerly Cooper Cameron Corporation (CCC) and Cooper Oil Tool, Cameron Iron Works) though now operating under Schlumberger, is a global provider of pressure control, production, processing, and flow control systems as well as project management and aftermarket services for the oil and gas and process ...