When.com Web Search

  1. Ad

    related to: linksys router bridge mode setup guide printable instructions

Search results

  1. Results From The WOW.Com Content Network
  2. Linksys routers - Wikipedia

    en.wikipedia.org/wiki/Linksys_routers

    Linksys manufactures a series of network routers. Many models are shipped with Linux-based firmware and can run third-party firmware. The first model to support third-party firmware was the very popular Linksys WRT54G series. The Linksys WRT160N/WRT310N series is the successor to the WRT54G series of routers from Linksys.

  3. SecureEasySetup - Wikipedia

    en.wikipedia.org/wiki/SecureEasySetup

    SecureEasySetup, or SES is a proprietary technology developed by Broadcom to easily set up wireless LANs with Wi-Fi Protected Access.A user presses a button on the wireless access point, then a button on the device to be set up (printer, etc.) and the wireless network is automatically set up.

  4. Linksys WRT54G series - Wikipedia

    en.wikipedia.org/wiki/Linksys_WRT54G_series

    The Linksys WRT54G Wi-Fi series is a series of Wi-Fi–capable residential gateways marketed by Linksys, a subsidiary of Cisco, from 2003 until acquired by Belkin in 2013. A residential gateway connects a local area network (such as a home network ) to a wide area network (such as the Internet ).

  5. Network bridge - Wikipedia

    en.wikipedia.org/wiki/Network_bridge

    The bridge has three ports. A is connected to bridge port 1, B is connected to bridge port 2, C is connected to bridge port 3. A sends a frame addressed to B to the bridge. The bridge examines the source address of the frame and creates an address and port number entry for host A in its forwarding table. The bridge examines the destination ...

  6. Forwarding information base - Wikipedia

    en.wikipedia.org/wiki/Forwarding_information_base

    The label edge routers at the edges of an MPLS cloud map between the end-to-end identifier, such as an IP address, and a link-local label. At each MPLS hop, there is a forwarding table that tells the label-switched router which outgoing interface is to receive the MPLS packet, and what label to use when sending the packet out that interface.

  7. OpenWrt - Wikipedia

    en.wikipedia.org/wiki/OpenWrt

    Ubiquiti's wireless router firmwares are based on OpenWrt; Diverse grassroots projects for wireless community networks, including Freifunk, Libre-Mesh and qMp; Some TP-Link, Xiaomi, ZyXEL and D-Link router firmwares are derived from OpenWrt [80] [81] FreeWRT was a Linux distribution that was used in embedded systems such as WLAN devices from ...

  8. Multiprotocol Encapsulation over ATM - Wikipedia

    en.wikipedia.org/wiki/Multiprotocol...

    This is distinct from other "bridge modes" commonly found in combined DSL modems and routers, which turn off the router portion of the DSL modem. In VC Multiplexing (VC-MUX), the hosts agree on the high-level protocol for a given circuit. It has the advantage of not requiring additional information in a packet, which minimises the overhead.

  9. Routing bridge - Wikipedia

    en.wikipedia.org/wiki/Routing_Bridge

    A routing bridge or RBridge, also known as a TRILL switch, is a network device that implements the TRILL protocol [1] and should not be confused with BRouters (Bridging Routers). RBridges are compatible with previous IEEE 802.1 customer bridges as well as IPv4 and IPv6 routers and end nodes.