Search results
Results From The WOW.Com Content Network
An abreuvoir is a watering trough, fountain, or other installed basin: originally intended to provide humans and/or animals at a rural or urban watering place with fresh drinking water. They were often located at springs. In pre–automobile era cities, they were built as equestrian water troughs for horses providing transportation.
Corrugated galvanised iron roofing in Mount Lawley, Western Australia A corrugated iron church (or tin tabernacle) in Kilburn, London Corrugated iron in the Cobar Sound Chapel, used both for the roof and as the formwork for the concrete interior Typical corrugated galvanised iron appearance, with visible large flake type patterns.
Culverts come in many sizes and shapes including round, elliptical, flat-bottomed, open-bottomed, pear-shaped, and box-like constructions. The culvert type and shape selection is based on a number of factors including requirements for hydraulic performance, limitations on upstream water surface elevation, and roadway embankment height.
The pipe sizes that are in use today in PVC and galvanized were originally designed years ago for steel pipe. The number system, like Sch 40, 80, 160, were set long ago and seem a little odd. For example, Sch 20 pipe is even thinner than Sch 40, but same OD.
The earliest spigot and socket cast iron pipes were jointed by filling the socket with a mixture of water, sand, iron filings and sal-ammoniac (ammonium chloride.) A gasket ring was pushed into the socket round the spigot to contain the mixture which was pounded into the socket with a caulking tool and then pointed off. This took several weeks ...
The majority of the troughs were installed in Victoria and New South Wales between 1930 and 1939. [1] Initially the troughs were individually designed and constructed, however by the early 1930s, J. B. Phillips, a relative of the Bills, became the head contractor. Working to a standard design he produced the troughs in Auburn Road in Hawthorn. [4]
Water is delivered from below, absorbed by upwards, and the excess collected for recycling. Typically, a solution of water and nutrients floods a container or flows through a trough for a short period of time, 10–20 minutes, and is then pumped back into a holding tank for reuse. Sub-irrigation in greenhouses requires fairly sophisticated ...
An elevated water tank, also known as a water tower, will create a pressure at the ground-level outlet of 1 kPa per 10.2 centimetres (4.0 in) or 1 psi per 2.31 feet (0.70 m) of elevation. Thus a tank elevated to 20 metres creates about 200 kPa and a tank elevated to 70 feet creates about 30 psi of discharge pressure, sufficient for most ...