Search results
Results From The WOW.Com Content Network
The Dana/Spicer Model 70 is an automotive axle manufactured by Dana Holding Corporation and has been used in OEM heavy duty applications by Chevrolet, Dodge, and Ford.It can be identified by its straight axle tubes, 10 bolt asymmetrical cover, and a "70" cast in to the housing, which is visually similar to the Dana 60.
The first version was produced from 1985 to 1992. The second version, produced from 1993 to 1997 featured a stronger pinion/yoke. This corrected a known, but rare, issue of the pinion yoke nut working loose. The first and second versions of the 10.25 axle are colloquially known as “short pinion-yoke” and “long pinion-yoke” respectively.
However, the 10.5" 14-bolt axle remains in production today, specifically utilized in GMC Savana and Chevrolet Express vans. Notably, the 11.5" 14-bolt axle is featured in third-generation Dodge Ram 2500 and 3500 trucks. There are discernible differences between the GM and Ram versions, evident in the gaskets used and the axle cover designs.
The Dana/Spicer Model 80 is an automotive axle manufactured by Dana Holding Corporation and has been used in OEM heavy duty applications by Chevrolet, Dodge, and Ford.It can be identified by its straight axle tubes, 10 bolt asymmetrical cover, and a "80" cast into the housing.
Axle shaft diameter 1.41” Front (32 spline) 1.46” Rear (32 spline) 1.50” Front (35 spline) 1.50” Rear (35 spline) Inner axle shaft splines: 16, 23, 30, 32, 33 or 35 Aftermarket inner axle shaft splines: 40 for after market, high performance axles, equivalent to Dana 70 components; Pinion shaft diameter: 1.625" Pinion shaft splines: 10 or 29
Although this axle is designed for medium-duty, commercial-trucks, Ford did put the S110 in 2008-2010 & 2015-2016 F-450 Pick up trucks. The Dana S110 has a GAWR up to 14,706 lbs but is frequently, de-rated by vehicle manufacturer for safety and tire reasons. This axle is not used in 1 Ton trucks . Dana S110 in a 2008 Ford F-450 Cab/Chassis
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
When installing lug nuts, it is recommended to tighten them with a calibrated torque wrench. While a lug, socket, or impact wrench may be used to tighten lug nuts, the final tightening should be performed by a torque wrench, ensuring an accurate and adequate load is applied. Torque specifications vary by vehicle and wheel type. Both vehicle and ...