Search results
Results From The WOW.Com Content Network
ASTM A325 is an ASTM International standard for heavy hex structural bolts, titled Standard Specification for Structural Bolts, Steel, Heat Treated, 120/105 ksi Minimum Tensile Strength. It defines mechanical properties for bolts that range from 1 ⁄ 2 to 1 + 1 ⁄ 2 inches (13 to 38 mm) in diameter. [1]
The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than 1 / 4 inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.
They are usually made of low grade steel, have a slot or Phillips drive, and are used to join sheet metal parts using a hex or square nut. [12] plow bolt: plough bolt: A plow bolt is bolt similar to a carriage bolt, except the head is flat or concave, and the underside of the head is a cone designed to fit in a countersunk recess.
This is also referred to as the "major" diameter in the information below. It indicates the diameter of smooth-walled hole that a male thread (e.g. on a bolt) will pass through easily to connect to an internally threaded component (e.g. a nut) on the other side. For example, an M6 screw has a nominal outer diameter of 6 millimetres and will ...
ISO 898 is an international standard that defines mechanical and physical properties for metric fasteners.This standard is the origin for other standards that define properties for similar metric fasteners, such as SAE J1199 and ASTM F568M. [1]
The contemporary square drive screw has all but replaced the Robertson screw proper and is commonly referred to as a Robertson because it has practically identical drive dimensions and the same colour identification system, but the contemporary square drive socket has parallel sides rather than tapered.
Sex bolt: Barrel nut, barrel bolt, binding barrel, Chicago screw, post and screw or connector bolt Has a barrel-shaped flange and protruding boss that is internally threaded Split nut: Split lengthwise into two pieces (opposed halves) so that its female thread may be opened and closed over the male thread of a bolt or leadscrew Sleeve nut ...
British Standard Fine (BSF) is a screw thread form, as a fine-pitch alternative to British Standard Whitworth (BSW) thread. It was used for steel bolts and nuts on and in much of Britain's machinery, including cars, prior to adoption of Unified, and later Metric, standards.