Search results
Results From The WOW.Com Content Network
Whether you are looking for ceiling ideas for your living room, bedroom, or kitchen, we have inspirational rooms topped with rustic stained tongue-and-groove pine planks, farmhouse perfect painted ...
39 in (990 mm) wainscoting using 3 in (76 mm) tongue and groove pine boards. Panelling (or paneling in the United States) is a millwork wall covering constructed from rigid or semi-rigid components. [1] These are traditionally interlocking wood, but could be plastic or other materials.
Tongue and groove joints allow two flat pieces to be joined strongly together to make a single flat surface. Before plywood became common, tongue and groove boards were also used for sheathing buildings and to construct concrete formwork. A strong joint, the tongue and groove joint is widely used for re-entrant angles
Wood can be stained using dyes or pigmented finishes. These finishes are available in a wide variety of colours, many of which are not part of the natural colour palette of wood, for example, blues and greens. Pigmented stains tend to highlight the grain (and also sanding scratches), whereas dyes do not have this effect and are more transparent.
Bed-mould or bed moulding: Narrow moulding used at the junction of a wall and ceiling, found under the cornice, of which it is a part. [2] Similar to crown moulding, a bed mould is used to cover the joint between the ceiling and wall. Bed moulds can be either sprung or plain, or flush to the wall as an extension of a cornice mould. [3]
wall-plates (at the top of timber-framed walls that support the trusses and joists of the roof). When jettying, horizontal elements can include: The jetty bressummer (or breastsummer), where the main sill (horizontal piece) on which the projecting wall above rests, stretches across the whole width of the jetty wall. The bressummer is itself ...
A through groove (left) and a stopped groove. In joinery, a groove is a slot or trench cut into a member which runs parallel to the grain. A groove is thus differentiated from a dado, which runs across the grain. [1] Grooves are used for a range of purposes in cabinet making and other woodworking fields.
Lath and plaster is a building process used to finish mainly interior dividing walls and ceilings. It consists of narrow strips of wood which are nailed horizontally across the wall studs or ceiling joists and then coated in plaster. The technique derives from an earlier, more primitive process called wattle and daub. [1]