Search results
Results From The WOW.Com Content Network
The HEI system has 40% more voltage output and 85% higher energy level than conventional breaker point systems to fire lean fuel mixtures even under adverse conditions. There were many design variations over the years, and provisions for computer controls were added for some applications starting in the late 1970s.
A coil wire is of the same construction as a spark plug wire, but generally shorter and with different terminals. Some distributors have an ignition coil built inside them, eliminating the need for a separate coil wire, such as the High Energy Ignition (HEI) system used by General Motors in the 1970s and 1980s.
The ignition coil is a transformer. The primary winding (called the low-tension winding in early texts) is connected to the battery voltage when the points are closed. Due to the inductance of the coil, the current in this circuit builds gradually. This current creates a magnetic field in the coil, which stores a quantity of energy.
An ignition coil is used in the ignition system of a spark-ignition engine to transform the battery voltage to the much higher voltages required to operate the spark plug(s). The spark plugs then use this burst of high-voltage electricity to ignite the air-fuel mixture. The ignition coil is constructed of two sets of coils wound around an iron ...
Ignition system of a flat-twin Citroën 2CV. A wasted spark system is a type of ignition system used in some four-stroke cycle internal combustion engines.In a wasted spark system, the spark plugs fire in pairs, with one plug in a cylinder on its compression stroke and the other plug in a cylinder on its exhaust stroke.
So, still see tremendous opportunity to continue to drive that. I think we've just scratched the surface. I'm really excited about how that's going to help us drive growth.
A variation coil-on-plug ignition has each coil handle two plugs, on cylinders which are 360 degrees out of phase (and therefore reach top dead center (TDC) at the same time); in the four-cycle engine this means that one plug will be sparking during the end of the exhaust stroke while the other fires at the usual time, a so-called "wasted spark ...
Some electronic ignition systems exist that are not CDI. These systems use a transistor to switch the charging current to the coil off and on at the appropriate times. This eliminates the problem of burned and worn points, and provides a hotter spark because of the faster voltage rise and collapse time in the ignition coil.