When.com Web Search

  1. Ads

    related to: jeep dana 300 lomax gear

Search results

  1. Results From The WOW.Com Content Network
  2. AMC and Jeep transmissions - Wikipedia

    en.wikipedia.org/wiki/AMC_and_Jeep_transmissions

    One common modification of the Dana 300 is to add oil paddles to the main shaft to prevent oil starvation of the rear bearing. The Dana 300 was used in Jeep CJs from 1980 to 1986. The 1980 factory original came with a shorter tail housing and a longer rear drive shaft. The Dana 300 should fit behind all TorqueCommand 4x4 transmissions ...

  3. Jeep CJ - Wikipedia

    en.wikipedia.org/wiki/Jeep_CJ

    Warner T-18 (four-speed with a Dana 20 1976-1979) (aftermarket adapters exist for a dana 300, but it was not a factory option) (also known as a three-speed with granny gear) Borg-Warner T-4 (four-speed with a Dana 300) Borg-Warner T-5 (five-speed with a Dana 300) Tremec T-150 (three-speed manual transmission with a Dana 20 1976-1979) Tremec T ...

  4. Chrysler NSG370 transmission - Wikipedia

    en.wikipedia.org/wiki/Chrysler_NSG370_transmission

    The Chrysler NSG370 is a six-speed overdrive manual transmission sourced from Mercedes and built in the Stuttgart Transmission Plant. [1] It is Jeep's first six-speed manual transmission and Chrysler's second after the Dodge Viper T-56.

  5. List of Chrysler transmissions - Wikipedia

    en.wikipedia.org/wiki/List_of_Chrysler_transmissions

    Commonly found in the 300, Magnum, Charger, Challenger, WK/WK2/WD Grand Cherokee and Durango (through 2013), Wrangler, and some Dodge Ram pickups. The A580 was last built at Kokomo II in August 2018, and remaining inventory was used in the 2019 - 2020 Dodge Charger Pursuit models.

  6. Jeep four-wheel-drive systems - Wikipedia

    en.wikipedia.org/wiki/Jeep_four-wheel-drive_systems

    In "4-Lo" mode, the input shaft drives through a 2.72:1 reduction planetary gear set and the front and rear axles are locked together through the clutch pack. This same NV247 transfer case is the foundation for the Quadra-Drive system described below. In 2005 Jeep replaced the New Venture Gear NV247 transfer case with the NV245 transfer case ...

  7. Dana 44 - Wikipedia

    en.wikipedia.org/wiki/Dana_44

    Dana 44 Front axles were known for utilizing locking hubs or a center axle disconnect system. However, a permanently locked-in Dana 44 is not uncommon. The Dana 44 has seen use in 1/4-, 1/2-, 3/4-, and 1-ton rated trucks. The Dana 44 was manufactured in kingpin and ball joint variations, as well as closed and open knuckle variations.